Samsung SDR3100 user manual SeTTinG THe eVenT, Motion Detection, Setting the motion Detection area

SeTTinG THe eVenT

You can set recording options for motion, and video loss event.

motion Detection

You can set target detection region and motion, as well as the alarm signal output.

When the motion detection region is set, it detects motion within the area.

Using the mouse may help make setup easier.

1.Use the up/down buttons ($%) in <event> window to move to <motion Detection>, and press [enTeR] button.

A window of motion detection area setup appears.

!main menu

2.Use direction buttons ($%_ +) to move to a desired item, and set the value.

•Mode : Sets whether to activate motion detection.

•Sensitivity : Sets the sensitivity level of the motion detection.

•Alarm : Sets the alarm output method.

`For further information on alarm output, refer to “HDD Alarm > Alarm”. (Page 48)

•Alarm Duration : Sets the duration of alarm signal and alarm sound.

3.When the motion detection setup is done, press <OK>.

Motion Detection

CH	Mode 		Sensitivity 	Alarm 	Alarm Duration 
1	OFF		Level10(High) 	None	10 sec	
2	OFF		Level10(High) 	None	10 sec	
3	OFF		Level10(High) 	None	10 sec	
4	OFF		Level10(High) 	None	10 sec	
					Motion Region
			OK	Cancel

Setting the motion Detection area

①Select <motion Region>.

②When “motion Region” window appears, select a channel for detection and set the area of motion detection.

• To set the area in “motion Region” window
In the “motion Region” window, select desired region		Motion Region
		CH1
from <	>.
				Individual	Apply to All CH
• To set the area using <individual> selection			OK	Cancel
In the “motion Region” window, you can select cells
individually by using <individual>.
When selected <individual>, “motion Region” window disappears and you can select cells one by one.
When the motion area setup is done, Right-click to select <menu> in the context menu or the [menu]
button on the remote control to display the “motion Region” window again.
- Select : Selected cell is set to be a part of motion detection area.
					Select
- Unselect : Selected cell is removed from the motion detection area.					Unselect
- Inverse : Unselected cells are set to be the motion detection area.					Inverse
- Menu : After selecting individual motion areas, move to the “motion Region” window.
					Menu
` If selected <Apply to All CH>, selected motion area is applied to all channels.
③ When the motion detection setup is done, press <OK>.

English _55