D771
Universal Remote Control
Owner’s Manual
Thank you for purchasing this RCA universal remote control. This product is designed to operate a wide variety of video and audio components. Please retain this guide for future reference.
This universal remote control is already programmed for most RCA, GE, and PROSCAN branded TVs, VCRs, DBS systems (manufactured before 2003), and DVD players.
Note: For users of RCA and PROSCAN DBS products: Older DBS models require that the INFO or MENU key on this remote be used to make program selections. Use the OK key for making program selections on newer RCA and PROSCAN DBS models. If your satellite receiver was purchased after 2003, programming the remote is
required.
Battery Installation and Information
Your universal remote requires 2 new AA alkaline batteries (sold separately).
To install the batteries:
1.On the back of the remote, push down on the cover and slide it off.
2.Insert the batteries, matching the batteries to the (+) and
3.Slide the battery cover back into place.
Note: Reprogramming may be required after batteries are replaced.
Battery Precautions:
•Do not mix old and new batteries.
•Do not mix alkaline, standard
•Always remove old, weak or
Care and Maintenance
•Keep the remote dry. If it gets wet, wipe it dry immediately.
•Use and store the remote only in normal temperature environments.
•Handle the remote gently and carefully. Don’t drop it.
•Keep the remote away from dust and dirt.
•Wipe the remote with a damp cloth occasionally to keep it looking new.
•Modifying or tampering with the remote’s internal components can cause malfunction and invalidate its warranty.
ANTENNA In TV Mode, lets you switch the source of the video signal from satellite signals to an
ARROWS Use the navigation arrows to move the on- screen highlight up, down, left, or right. Using the arrows to highlight a menu item is also called “pointing.”
CH + (up)/ - (down) Use to scan up and down through the channels in the current channel list. If you are in the program guide or menu system, use the CH +/- keys to page up and down a screen at a time. You can also use the CH +/- keys on the top of the digital satellite receiver to change the channel.
CLEAR Removes the
COMPONENT KEYS When programmed, these keys are used to put the remote in a specific mode so that it can control that component.
AUX1 and AUX2 Act as “wildcard” keys. They can be programmed to control another TV, VCR, DVD, satellite receiver, cable box, or an audio component. Follow the direct entry programming instructions to program these keys.
Note: The AUX1 key is
DVD Puts the remote in DVD Mode.