Universal Electronics URC-2505 manual Helpful Hints, Problem Solution

■ ■ ■ ■

Helpful Hints

Problem:		Solution:
	Red light does not	Replace batteries with 4 fresh,
	blink when you press	new AAA alkaline batteries.
	a key?
	The ONE FOR ALL	Make sure you are using new
	does not respond after	batteries and are aiming the
	pressing a key?	ONE FOR ALL at your device.
	The ONE FOR ALL	A) Try all the codes listed for
	does not operate your	your brand. B) Try the search
	device(s)	method on page 13.
	Your brand is not	Try the search method on page 13.
	listed in the ONE FOR
	ALL code section?
	When following the	Did you use the Code Lock
	set-up instructions, the	feature? You must first unlock
	red light on the ONE	the code before entering a new
	FOR ALL only blinks	code. Follow the instructions
	once instead of twice	on page 22 to do this.
	after you enter a
	three-digit code?
	The ONE FOR ALL	You may be using the wrong code.
	is not preforming	Start the search method over
	commands properly?	again to locate the proper code.
	Press a key but get	Hold MAGIC until the red light
	the wrong result?	blinks twice, then press 992 and
		the device key twice. You will
		need to set-up your device again.
		Try the codes for brand or the
		search method on page 13.
	You cannot control the	Hold MAGIC until the red light
	volume feature of your	blinks twice. Then press 993 and
	Satellite, Cable	VOL+. To set the volume control
	Converter or TV/Video	back to TV (Punch Through),
	Combination?	hold MAGIC until the red light
		blinks twice, then press 993 TV.
	Problems changing	Enter the programme number
	channels?	exactly as you would on your
		original remote.
	Video not recording?	As a safety feature on your ONE
		FOR ALL, you must press the
		Record key twice .
	Scan does not work	Make sure your original remote
	on your device?	had a programme +/- key.

■ ■ ■ ■

26