Staub Electronics NU1000R manual Keyless En try, Alarm Mode, Auto-Start Fun ction

Page 4

Step1: Activate Valet/ Programming mode by manually turning the ignition on and off five times (between Acc and On) with the key within a 7 second period.

The parking lights will flash once with successful completion of this step.

Step2 : Within a 7 second period after cycling the ignition for the 5 th time,

Press the button for a 1/2 sec. The parking lights will flash once to confirm that the transmitter has been programmed. You can continue programming additional remotes. The parking lights will flash two times when the programming mode has expired.

Keyless En try

To lock the vehicle, press thebutton for 0.5 seconds.

To unlock the vehicle, press the button for 0.5 seconds. If the pressing of the lock/unlock buttons does not lock/unlock the doors, you will need to release the button and try again, as the remote stops transmitting as soon as the LED stops

flashing. If the button is pressed for 3.5 seconds, it will panic the system.

Alarm Mode

To arm the vehicle, press thebutton until the LED on the remote stops flashing.

To disarm the vehicle, press the button until the LED on the remote stops flashing. If pressing the arm/disarm buttons does not arm/disarm the vehicle, you will need to release the button and try again, as the remote stops transmitting as soon as the LED stops flashing.

Press the buttons for a 1/2 second to mute the vehicle horn or siren when arming or disarming your vehicle. Keep in mind that your horn/siren will still activate for all other modes (i.e. panic or alarm trigger) regardless of whether or not your horn/siren is in mute mode. The horn/siren will be mute only when arming or disarming your vehicle.

When the alarm is armed, the starter kill function (an optional feature provided by your installer) is activated. This feature disengages the starter mechanism on your vehicle and prevents it from starting, even with a key.

Note : If you lose your remote after you have armed the vehicle, use your key to open the door. The siren will go off. Turn the ignition on then off,

5 times with your key to shut down the alarm and put the system into valet mode. You can cancel the valet mode with a remote later on. See : Valet mode, on page 10.

Note : Siren duration is 30 to 60 seconds depending on the options set at the time of initial installation.

Auto-Start Fun ction

Press the button for 2 seconds to auto-start an automatic transmission engine. Remember, that an actual key in the ignition is required to drive the car. For manual transmission vehicles, please use reservation mode.

Press the button for 2 seconds in order to turn off an auto-started car.

The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset options at the time of installation, and then shut off.

Diagnosing problems with Auto-Start

If there is a problem in auto-starting your vehicle,the NUSTART system will do one of two things; if it fails for any of the reasons listed in the table below, it will flash the parkinglights three times then flash the error number. Otherwise, it will attempt to start the vehicle three times. If, after three times, the vehicle will not start or stay running, the NUSTART system will shut down. In either case, please see your istaller to resolve the situation.

Error Number

Error Reason

(# of times the car chirps & parking lights flash)

 

 

 

1

Engine On

2

Key On

3

Door Open

4

Trunk Open

5

Brake On

6

Hood Open

7

Reservation Off (Manual Transmission Only)

 

 

Page 6

Page 7

Image 4
Contents USER’S Guide Nu1000RTable of Contents Safety Information Remote Nu1000RRemote Button Functions Remote Learn RoutineAlarm Mode Diagnosing problems with Auto-StartKeyless En try Auto-Start Fun ctionPanic Mode Reservation Mode manual transmission onlyTrunk Release Optional Programmable Features Optionalinstallation Features Cold Start ModeLimited Lifetime Consumer Warranty Optional Auxiliary 1 & AuxiliaryYour warranty