Gate Receiver
Model R4G
1. INTRODUCTION
The R4G receiver is an access control receiver capable of having up to 1000 remote controls. Each remote control can be individually added, deleted, or temporary disabled. The following advanced features are also available:
·
·
·
·
NC / NO output selection
Relay latch / momentary contact selection
Latch duration
Momentary contact duration
Antenna Connector – For connection to direct antenna or with coax cable to a remote antenna
Relay – Lights when the relay is triggered
Program – Lights when the receiver is in program mode, it will not receive any incoming signal during programming
ADV SET – Advanced Features/Advanced settings
Occupied – Lights when the displayed memory location (remote) is occupied
Blocked – Lights when the displayed memory location (remote) is blocked
|
|
|
|
|
|
|
| LED display – Display |
|
|
|
|
|
|
|
| selected memory location |
|
|
|
|
|
|
|
| DISP – To display information for the |
|
|
|
|
|
|
|
| memory location such as occupied |
|
|
|
|
|
|
|
| remotes, blocked remotes, empty |
|
|
|
|
|
|
|
| memory locations etc |
|
|
|
|
|
|
|
| ADD – To add remote control to the |
|
|
|
|
|
|
|
| receiver |
|
|
|
|
|
|
|
| DEL – To delete a remote control |
|
|
|
|
|
|
|
| ACT – To activate or inactive a |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| remote control (This function may |
|
|
|
|
|
|
|
| be called Block and Unblock) |
|
|
|
|
|
| Relay Com | Scroll Down – Scroll all the memory | |
|
|
|
|
|
| locations to check their status, such | ||
|
| NO Contact |
|
| ||||
|
|
|
| as occupied, blocked, empty etc. | ||||
2. INSTALLATION
1.Hang the receiver with 2 screws (Provided in the package).
2.Connect the push button or radio terminals to the 2 contacts labeled “Relay Com” and “NO Contact”.
3. Connect the 12V – 24V AC/DC power supply to the 2 indicated terminals. You will hear 3 beeps after plugging in the power supply.
3. OPERATION
Basic functions
Add Remote Controls to auto assigned location
Display |
| Display |
ADD | ||
|
| remote is programmed to the memory location [0 0 0]. |
Press | Press |
|
Display will then show the next available memory location.
Press 
DISP 
twice to exit or add another remote by pressing its button.