Universal Electronics PVR 5 manual To Program a Tune-In Key, To Clear a Tune-In Key

Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 17

To Program A “Tune-In” Key:

1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice, then release SETUP.

2. Enter 9 - 9 - 5. The CBL key will blink twice. Then select a “Tune-In” key and press it once.

3.Press CBL once followed by the channel number to be programmed (e.g., 3 - 9).

NOTE: If you are programming a channel for a Digital Cable Converter, you need to enter all channels in a 3-digit channel format. For example, if the desired channel is 39, then enter it as 0 - 3 - 9.

4. Press and hold SETUP until the CBL key blinks twice, then release SETUP.

5.To add another channel, repeat steps 1 through 4, substituting the new channel to be added in step 3.

NOTE: Programming more than five channels on the same “Tune-In”key will overwrite previous settings.

To Clear A “Tune-In” Key:

1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice, then release SETUP.

2. Enter 9 - 9 - 5. The CBL key will blink twice. Then select a “Tune-In” key you want to clear and press it once.

3. Press and hold SETUP until the CBL key blinks twice, then release SETUP.

4.This “Tune-In” key is now clear and ready for reprogramming (see above – To Program A “Tune-In” Key). If desired, repeat steps 1 though 3 in this section to clear another “Tune-In” key.

17