Sunwave Tech SRC-3820 manual Appendix C Troubleshooting, Troubleshooting Tables

Page 50

SRC-3820 User’s Manual

Appendix C – Troubleshooting

Troubleshooting Tables

Problem

Solution

LCD does not

1. Batteries may be dead. Renew

show anything

batteries with 4 x AAA alkaline

when you tap it or

batteries.

press any hard

2. Check the batteries if they are

buttons

properly installed.

 

 

One of devices

1. Make sure that you turn on the

can not be

control screen of device on SRC-

controlled

3820.

 

2. Move closer to the target device. The

 

maximum operating distance is

 

approximately 30 feet.

 

3. Ensure that the SRC-3820 is aiming at

 

the target device, and there is no

 

obstruction between remote and the

 

target device.

 

4. Ensure that the SRC-3820 has codes

 

inside for the target device.

 

 

An “ERROR

1. Make sure you press each hard

message is

button of original remote at least over

displayed on

2 seconds.

screen while the

2. Make sure the original remote would

Learning function

aim at learning eye of SRC-3820

is in progress

straightly.

 

3. Keep 2~4 inches (5~10 cm) apart

 

between SRC-3820 and the original

 

remote.

 

 

44

Image 50
Contents SRC-3820 050805Page Preface Table of Contents Iii Page Introducing the SRC-3820 SRC-3820 Features Unpacking the SRC-3820Identifying Components Front ViewInstalling Batteries This chapter provides you to get using the SRC-3820 quicklyBattery Indicator Battery Tips and PrecautionsTurning the LCD On Precautions of Using the Touch ScreenAbout the Touch Screen Please read the following instructions carefullyUsing Hard Buttons Favorite Channels Group ButtonEntering the Setup Menu Navigating the Setup MenuSetup Menu Tree Setting Up the SRC-3820 Device MenuSection will instruct you how to create a new device Creating a New DeviceSection will instruct you how to edit a device label Re-labeling a DeviceDeleting a Device Code Menu Using Pre-code to Program Devices Selecting the code manuallySelecting a code automatically Using Code Learning Mode Learning from another Remote ControlPage Section will instruct you how to delete key codes Erasing a Key CodeErasing a Device Codes LCD Layout Using Macros Section instructs you how to create a macro key Creating a New MacroHow to set up a time delay? Section will instruct you how to delete a macro key Deleting a MacroViewing a Macro Menu, tap and to browse through following options Setting Quick CHsSetting a Quick CH Deleting a Quick CH Relabeling a Quick CH Using Timer Creating a timer at the Sleep mode Page Creating a timer at the Date mode Creating a timer at the Week mode Deleting a timer Section will instruct you how to delete a timerUsing the Transmission Feature Miscellaneous Menus Setting the Date and Time Setting the Power Time Setting the BacklightSetting the Beep Checking the Version NumberResetting the SRC-3820 back to Factory Default Appendix a Specifications Appendix B Accessories USB cableAppendix C Troubleshooting Troubleshooting TablesWhen you enter Code number