| AC502 |
Under Dash | Nut Bracket |
Mounting | Label |
|
Nut
Knob
Screws
In-Dash Mounting
Note: There must be enough clearance behind the dash-panel before selecting the location to mount the RGC-1.
A 1/2-inch hole must be drilled to mount the RGC-1 in the dash panel. Side in the control from the rear of the dash panel and place the trim label on the threaded shaft. Secure the control with the nut and mount the knob
If there is no access to the back of the dash panel, drill a 3/4-inch hole in order to pass the entire RGC-1 through the hole from the front of the dash panel. Once the control is through the hole, the clip shown below is passed through the hole and slid around the threaded shaft of the control. Place the trim label on the threaded shaft and secure the control with the nut and mount the knob.
| AC502 | |
Front Mount | Nut | Dashboard |
|
| | Clip |
| | Trim Panel |
| | Label |
Rear Mount | | Nut |
| Knob |
| |
AC502
Nut
Dashboard
Label Nut Knob
2 | ©2003 Directed Electronics, Inc. |
