Crisp Solutions 616 manual Dsp

UCommand-616 Universal Remote Control User’s Manual

You cannot operate a	∙ Make sure that you have correctly “mapped”
device even after	your device’s remote control to the
configuring the device	UCOMMAND-616.
using the learning	∙ Clear the device data from the
function (page 26).	UCOMMAND-616 (page 30) and carry out
	the learning function again (page 26).
	∙ Some original remotes have an unstable
	timing, which cannot be learned. Try learn-
	ing the commands from a different remote
	control, such as a universal remote, config-
	ured to control the respective device.
You see an “error”	∙ Try the learning procedure again (page 26).
display during the	If the remote is FULL, remove any buttons
learning procedure.	or devices you feel unnecessary.
You see an “error”	∙ The button that you pressed has not been
display during opera-	properly configured. Configure the button
tion.	again using the learning procedure (page
	26).
Problems with two-	∙ Some remotes use a string of commands to
way remotes and	trigger certain functions. This is especially
DSP	true of DSP (surround sound) functions. Try
	programming the UC-616 with the Device
	turned off, or do the programming in another
	room. Alternately, during the Learning se-
	quence, quickly move the remote away from
	the 616 after sending the original command.
The LCD screen	∙ The UCOMMAND-616 is preset at the fac-
turns off.	tory to automatically switch the LCD off after
	20 minutes if left unused. Press the Hard-
	ware Access Button	or any other hard
	button to turn the UCOMMAND-616 back on
	again.
Short battery life	∙ This is usually caused by heavy use of the
	backlight function, which mainly determines
	the battery life (see pages 11 and 50).

56 Troubleshooting