WIRELESS
For Use With DESA Heating Products Remote Ready Log Sets
and Fireplace Systems
Installing Remote Receiver
1.Disconnect switch wires from the control valve. Some units will have an on/off switch with switch plate that is connected to the control valve. Other units will have a jumper wire that will need to be removed from the control valve (see Figure 1).
2.Remove screws and switch plate as shown in Figure 1. Discard after removing.
3.Install remote receiver unit onto gas log heater base using clips (2) and insulating washers provided.
4.Push clips firmly into place (see Figure 2).
5.Connect wires as shown in Figure 3.
Note: On yellow flame models, reuse provided phillips head screws and reinstall heat shield over receiving unit.
Front
Screw
Back
Wires to
Control Valve
ON/OFF Switch with
Switch Plate
INSTALLING WIRELESS REMOTE control ACCESSORY
Two
Installing 9-Volt Battery (Not Included) in
Receiver
1. Locate the battery clip mounted on the back of the receiver.
2. Slide a
3. Attach the terminal wires to the battery.
Mounting Front
Clips
Back
Remote
Receiver
Insulating |
|
Washers | Battery Clip |
Figure 2 - Installing Remote Receiver
Jumper Wire | Red Wire |
| |
From |
| ||
|
| ||
| Receiver |
| |
| White |
| |
| Wire From |
| |
Control Valve | Receiver | Valve | |
| |||
|
| ||
Figure 1 - Disconnecting Wires from | Figure 3 - Connecting Wires | ||
Control Valve | |||
|
| ||
Save for future reference.
For more information, visit www.desatech.com