Hitachi 51F510 To Move Adjustment Point, To Change the Color of Adjustment Point

SETUP

Manual Convergence Adjustment Mode (9 Point Manual Adjustment)

NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.

2.Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.

3.If Auto Adjust mode is selected or the Magic Focus button is pressed, all manual adjust mode settings will be erased.

Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-9 POINT MANUAL-START to access convergence 9 point pattern. The adjustment point is indicated by the Adjustment Point Cursor.

To Move Adjustment Point

To move the adjustment point cursor using the CURSOR buttons, the Adjustment Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED.

To Change the Color of Adjustment Point

Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.

To Adjust the Convergence

Move the Adjustment Cursor to the point to be adjusted. Use the CURSOR buttons to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white.

Video Setup

Audio		Magic Focus Tune Up
Aspect		Menu Preference
Chan. Manager		Set The Inputs
Locks		Set Virtual HD
		Set Black Side Panel
Timers
		Set Closed Captions
Setup		Set Monitor Out
Move	SEL Sel	Set AV Control
		About Your TV
		Move SEL Return

Adjustment Point

Cursor

Setup

Magic Focus Tune Up

Aligns the Red, Green, and Blue colors to correct for Magnetic Influences.

Adjustment Mode

Auto

9 Point Manual

117 Point Manual

If you want to adjust now Start

Move SEL Return

If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.

Setup

Magic Focus Tune Up

Manual Adjust

Please make a selection from the options below

Cancel

Done

Back

Reset

Move SEL Select

Use the CURSOR buttons to highlight your chosen option. Press the SELECT button to select.

Select CANCEL to cancel adjusted data and return to main picture.

Select DONE to save your adjustments and return to main picture.

Select BACK to return to the manual convergence adjustment mode.

Select RESET to recall the factory pre-set convergence data.

ON-SCREEN DISPLAY

57