Hitachi 50VS69A 55VS69A How to set up your new Hitachi Projection Television, Antenna, Location

Page 5

How to set up your new HITACHI Projection Television

ANTENNA

Unless your LCD Rear PTV is connected to a cable TV system or to a centralized antenna system, a good outdoor TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set. To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc. When using your LCD Rear PTV against a wall, keep it at least 10cm (4 inches) from the wall.

NOTE: Your new HDTV has a built-in high definition television signal processor. This television includes a fan to cool the processor. The sound of moving air from the fan is normal and may be noticeable in very quiet environments.

First time use

VIEWING

The major benefit of the HITACHI LCD Rear PTV is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

 

BEST

20

VERTICAL VIEWING

ANGLE

3'

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

0' 5' 10' 15' 20'

If the TV’s audio output will be connected to a Hi-Fi system’s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

R

 

 

 

S

 

 

20'

 

 

 

 

 

4" Minimum

50

BEST

 

 

 

 

 

 

 

 

HORIZONTAL

 

5'

 

10'

15'

20'

 

50

VIEWING ANGLE

 

4" Minimum

 

 

 

 

 

 

 

L

 

 

 

S

IMPORTANT NOTES:

1.Since LCD Rear PTV incorporates a high pressure lamp to display an image, it may take about one minute for the picture to become stable, after the power has been turned on. After extended use, the picture may darken, the color may look unusual, or the lamp “goes out,” (burns out). You may hear a “pop” sound when the lamp “goes out.” These are common characteristics of the lamp, and should not be considered defective.

2.LCD Rear PTV incorporates an advanced cooling fan system to prevent from overheating. If you hear the cooling fan, it should not be considered defective.

3.If you hear a “cracking” sound from the TV cabinet, it is due to the TV’s cabinet expanding and

contracting due to room temperature changes. It has no effect on the TV’s functions.

4.The LCD Rear PTV cabinet is constructed with wood and plastic. Make sure to place it on a flat surface. An uneven surface might warp the cabinet and reduce the picture quality.

5

Image 5
Contents LCD Rear Projection Television Read Before Operating Equipment Important Safety InstructionsPublic viewing of copyrighted material Power sourceLead/Mercury Notice For More INFORMATION, Call 1-800-HITACHIFirst time use AccessoriesRemote Control Battery Installation and Replacement Antenna How to set up your new Hitachi Projection TelevisionLocation ViewingUse Hook-up Cables and ConnectorsFirst time Antenna Connections to Rear Jack PanelQuick Reference Remote Control Buttons and Functions Front Input Jacks Input Front Panel ControlsLamp Indicator Power LightTemp Indicator Front Control Panel Connections Front Panel Jacks and ConnectionsMonitor OUT & HI-FI Audio OUT Rear Panel ConnectionsCableCARD Slot Information from Setup menu seeDigital Output Capability Tips on Rear Panel Connections Installation RecommendationConnecting AN S-VIDEO and Stereo Audio Source to Input 1 Connecting External Video SourcesConnecting a Video and Stereo Audio Source to INPUT1 INPUT5 DVI to Hdmi Input Connecting External Audio/Video Devices Connecting Optical OUT to AN External Audio Amplifier Connecting a Video and Monaural AudioConnecting Monitor OUT Source to Input 1 ~ InputRemote Control Remote ControlRemote How to Use the Remote to Control Your TVControl Expanded StandardZOOM1/ZOOM2 PICTURE-IN-PICTURE button Inputs buttonMenu button Exit buttonChannel CH Down First time use The Remote ControlWhite POP Mode PICTURE-IN-PICTURE Split Mode PICTURE-IN-PICTUREPicture-in-Picture PIP PIP buttonPIP Specifications Table PIP Mode PICTURE-IN-PICTUREStrobe Freeze Split FreezeMain Freeze Operating the Precoded Function for Your Cable BOX Remote Control for Cable Box FunctionsCodes Cable Brand Digital Type CodesSatellite Brand Codes Remote Control for Set-Top Box/Satelite Receiver FunctionsSET TOP BOX Brand Codes MY Satellite ReceiverDVD Brand Codes Remote Control for DVD FunctionsOperating the Precoded Function for Your DVD Player VCR Brand Codes Remote Control for VCR FunctionsOperating the Precoded Function for Your VCR On-Screen Display On-Screen DisplayVideo Screen Display VideoContrast Mode Color TemperatureAuto Movie Mode Black EnhancementBlack Side Panel Reset Video SettingsAudio DRC On-ScreenDisplay Start or Reset option Signal MeterChannel Manager Auto Channel ScanWhich are your Favorite FAV Channels Channel ListLocks Change Access CodeMotion Picture Ratings Table Movie RatingsTV Parental Guide Ratings Table TV RatingsCanadian Ratings English Table Canadian Ratings EngCanadian Ratings French Chart Info Alternate Ratings U.SSet The Clock TimersDaylight Saving Correction and press Use the Cursor PAD Or ChannelUse the Cursor Pads to select DAY Mode on Set Sleep TimerSet Day/Night Timer Event 2, Event 3, Event 4 and then press Set Event TimerSelect Start Time HOUR/MINUTE Select Start Time AM/PM Use the Cursor PADSet The Language SetupSet The Menu Options Set The Menu Background Set The Power SavingInput 4 Auto Link Set The InputsAuto RemoteSet The Closed Captions Caption ModeCaption Display Analog CaptionsVideo Out Set The Output TerminalsAudio Out Use Cursor PAD orCableCARD Information Things to Check When UsingCableCARD / CableCARD Services Upgrade NOW Reset The SoftwareReset TV Settings Set The Quick Start OptionsLamp Replacement Lamp ReplacementLamp Replacement Lamp Life120V Lamp Unit Turn clockwise to tighten the lamp cover screw Troubleshooting Equipment Care and TroubleshootingSwitch ON/OFF InformationUseful Information Reception ProblemsFCC Information Useful Info55VS69A 62VS69A Features and SpecificationsDimensions Useful HitachiHome Electronics Division Digital Media DivisionEND User License Agreement for Hitachi DTV Software End User License Agreement for Hitachi DTV SoftwareLicense Agreements Software License Information End User License Agreements for Operating System SoftwarePreamble End User License Agreement for Operating System SoftwareGNU General Public License Version 2, June No Warranty END of Terms and Conditions UXQWKDWSURJUDPXVLQJDPRGL¿HGYHUVLRQRIWKH/LEUDUy GNU Lesser General Public License Version 2.1, FebruarySRUWLRQVRIWKH/LEUDU\ZLOOVWLOOIDOOXQGHU6HFWLRQ HQJLQHHULQJIRUGHEXJJLQJVXFKPRGL¿FDWLRQV Agreements LicenseAppendix a AppendixAppendix Index IndexService Information Page Page Page QR67392