Hitachi 61SWX10B AV1, AV2, AV3, or CD, TAPE, AMP buttons, Channel selector buttons, Sleep button

Page 25

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV

AV1, AV2, AV3, or CD, TAPE, AMP buttons

When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (see page 34)

NOTE: Your remote control “SOURCE WIZARD” buttons are either labeled as “AV1, AV2 and AV3,” or “CD, TAPE, and AMP.” If your remote control “SOURCE WIZARD” buttons are labeled as “AV1, AV2, and AV3,” please program your Audio/Video components as follow for best performance. Use “AV1” to program your CD brand. Use “AV2” to program your TAPE brand, and use “AV3” to program your AMPLIFIER/RECEIVER brand.

AV1-Use for CD brand AV2-Use for TAPE brand

AV3-Use for AMPLIFIER/RECEIVER brand.

SOURCE WIZARD

AV1

AV2

DVD

AV3

CHANNEL selector buttons

CHANNEL selector buttons are used to set FAVORITE CHANNELS, CHANNEL MEMORY, etc.

Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.

Channel selection may also be performed by pressing CH up ( ) or down ( ).

NOTE: The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode. (see page 40)

SLEEP button

Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15 minutes to this timer, up to a maximum of three hours. Once set, use STATUS when you want to view time remaining. If the SLEEP button is pressed while the timer is set, it will reset to the original condition.

LAST CHANNEL (LAST CH) button

Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)

Ant A 10

LAST CH

Ant A 39

ANTENNA button

The ANT button will select between Antenna A and Antenna B each time the button is pressed.

Ant A 10

ANT

Ant B 28

C.C. button

Press this button to quickly turn the Closed Caption feature on, off and auto (see page 55 for more information).

HELP button

Press this button when a menu is displayed to view HELP text, which gives a description of the displayed menu. The HELP text will be displayed every time a MENU is displayed, until this button is pressed again.

ASPECT button

Press this button to quickly change the PICTURE FORMATS aspect ratio. (See page 46-47 for more information)

PIX or MODE button

Press this button repeatedly to direct access THEATER MODE between Sport, News, Movie, and Music.

MENU button

The MENU button will start the On-Screen Display.

EXIT button

When in MENU mode, this button will exit all On-Screen Displays.

25

Image 25
Contents Remote Control Important Safety Instructions First Time USE GeniusUltratec BIT-MAP ON-SCREEN Display Useful Information IndexPower Source Safety Tips Important Safety InstructionsOperation of Your Television Picture CautionsVID1 AccessoriesAntenna HOW to SET UP Your NEW Hitachi Projection TVLocation ViewingAntenna Connections to Rear Jack Panel HOOK-UP Cables and ConnectorsFront Panel Controls Remote Control sensor Power lightPerfect Picture sensor Magic FocusFront Panel Jacks and Connections Monitor OUT Rear Panel JacksRear Speaker Output Terminals Component Y-PBPRInputsOptical Input Coaxial InputRear Panel Connections Typical FULL-FEATURE Setup53/61SWX10B and 53/61SWX12B Models Rear Speaker Terminal Connections Connect After Turning the Power to the TV OFFConnecting External Audio Amplifier Connecting External Audio SourcesRear Panel of Television SUB Woofer Surround Required Optional Effect Feature ConnectionConnecting a Monaural Audio Source to INPUT1~INPUT5 Connecting External Video SourcesBefore Operating External Video Source Connecting a Stereo Source to INPUT1~INPUT5 Connecting AN S-VIDEO Source to Input 1, 2 Models 61UWX10BA, 53UWX10BA, 43UWX10B Connecting a Component Source to Video 4 or 5 Y-PBPRLight Button Genius Remote ControlCable CBL HOW to USE the Genius Remote to Control Your TVSET-TOP-BOX STB AV1, AV2, AV3, or CD, TAPE, AMP buttons PIX or Mode buttonChannel selector buttons Sleep buttonThumb STICK/SELECT button VOLUME, Mute buttonStatus button PICTURE-IN-PICTURE buttonsPICTURE-IN-PICTURE PIP Single Mode PIPPIP button Surf Mode PIP PICTURE-IN-PICTURE Split Mode PIPSingle SplitFreeze button With PIP OFF Freeze button With PIP onSingle Freeze Split FREEZEwith PIP offOperating the precoded function for your VCR Using the Remote to Control VCR FunctionsPrecoded VCR Buttons Exclusive TV ButtonsOperating the precoded function for your cable box Using the Remote to Control Cable BOX FunctionsCable CBL button Precoded Cable BOX buttonsPrecoded SET-TOP-BOX/SATELLITE Receiver buttons SET-TOP-BOX STB buttonOperating the precoded function for your DVD player Using the Remote to Control DVD FunctionsPrecoded DVD Buttons Precoded AUDIO/VIDEO Buttons AV1, AV2, AV3 ButtonsVCR BRAND. . . . . . . . . . . . . . . . . Code AUDIO/VIDEO CodesUltratec OSD Setup Customize Video Audio Theater SET Menu Language SET UPPlug & Play Plug & PlayReception Band SET ANTENNA/CABLESET Channel Memory Edit Channel Memory View Channel List SET the Clock Magic Focus Aspect Style Picture FormatsPosition FillComponent Color Type Video DisplayName the Channel CustomizeName the Inputs Name the InputsSET Favorite Channels Favorite Channels Operation Stick SET Parental LocksStick SET Program TimerVideo Input Sensor Display Closed CaptionMode ChannelVideo Contrast Brightness Color Tint Sharpness ResetColor Temperature Advanced SettingsPerfect Picture Auto ColorBass AudioTreble BalanceAuto Noise Cancel MTS ModePerfect Volume Internal Speakers2 5 0 1 K 1 0 K Dynamic Bass Theater Movie Mode 32 Pulldown Detection Special FeatureTheater Modes Surround OFF SurroundTechnology Use Thumb Stick To change Theater Modes settings Rock Arena Surround Stadium SurroundJazz Club Surround PRO Logic SurroundThumb Dolby PRO LogicDolby Digital Listenting Position Input SourceListening Mode Speaker Setup Do not Care of Your Hitachi Projection TV Your Remote ControlIgnition Noise Reception ProblemsUseful Info SymptomsOutputs InputsHome Electronics Division HitachiQR48043
Related manuals
Manual 76 pages 25.23 Kb