Hitachi 53FDX20B Using the Remote to Control VCR Functions, DVD/VCR Button, Precoded VCR Buttons

Page 26

USING THE REMOTE TO CONTROL VCR FUNCTIONS

Operating the precoded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR. (refer to page 29 for pre-codes)

1.Turn ON your VCR.

2.Aim the remote control at the front of your VCR.

3.Press and release the DVD/VCR button to switch to VCR pre-coded mode.

4.Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 29.

5.Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit preset code.

6.The remote will now control your VCR.

NOTES:

1.If your VCR cannot be operated after performing the above procedures, your VCR’s code has not been precoded into the remote.

2.In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

DVD/VCR Button

This button allows the remote to control your VCR by setting it to VCR mode.

	POWER
TV	CBL/SAT DVD/VCR
PIP	SWAP PIP MODE
PIP	FREEZE

PIP CH

HELPMENU

SELECT

MUTE	LAST CH
	EXIT

VOL CH

1 2 3

4 5 6

7 8 9

PRECODED VCR Buttons

These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button twice to record a program.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

ANT 0 STATUS

VID1	VID2	VID3	VID4
REC		ASPECT	MODE
	VID5

CLU-4322UG

MY VCR CODE IS:

NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.

26

Image 26

Contents ON-SCREEN Display Useful Information Index Important Safety Instructions First Time USE Remote ControlUltratec BIT-MAP Important Safety Instructions Safety Points YOU should Know about Your Hitachi TelevisionPrevention of Pattern Burn Public Viewing of Copyrighted MaterialAccessories Remote ControlLocation HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Perfect Picture sensor Power lightRemote Control sensor Magic FocusFront Panel Jacks and Connections Input OutputRear Panel Jacks Monitor OUTComponent Y-PBPRInputs Typical FULL-FEATURE Setup Rear Panel ConnectionsTips on Rear Panel Connections Tips on Rear Panel ConnectionsRear Panel of Television Connecting External Audio SourcesConnecting External Audio Amplifier Before Operating External Video Source Connecting External Video SourcesConnecting a Monaural Audio Source to INPUT1~INPUT5 Connecting a Stereo Source to INPUT1~INPUT5 VCRConnecting AN S-VIDEO Source to Input 1, 2 See tips onConnecting a Component Source to Video 4 or 5 Y-PBPR DVD PlayerAspect Button PICTURE-IN-PICTURE buttons HOW to USE the Remote to Control Your TVVOLUME, Mute button Help buttonAspect button Mode buttonVID1 ~ VID5 buttons Status buttonMenu button Last Channel Last CH buttonPIP CH button PIP button Single Mode PIPPICTURE-IN-PICTURE PIP Swap button PICTURE-IN-PICTURE Surf Mode PIPPIP Mode button SingleSingle Freeze Freeze button With PIP onFreeze button With PIP OFF Strobe FREEZEwith PIP offDVD/VCR Button Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Precoded VCR ButtonsPrecoded CABLE/SATELLITE BOX buttons Using the Remote to Control CABLE/SATELLITE BOX FunctionsCable CBL/SAT button Precoded DVD Buttons Using the Remote to Control DVD FunctionsOperating the precoded function for your DVD player CABLE, SATELLITE, VCR, and DVD Codes Ultratec OSD Setup Customize Video Audio Theater SET UP SET Menu LanguagePlug & Play Plug & PlaySET ANTENNA/CABLE Reception BandSET Channel Memory Edit Channel Memory View Channel List SET the Clock Magic Focus Picture Formats PositionSignal Picture FormatsComp Color Type Video DisplayCustomize Name the ChannelName the Inputs Name the InputsSET Favorite Channels Favorite Channels Operation SET Parental Locks CursorMotion Picture Rating Chart Movie RatingsTV Parental Guide Rating Chart TV RatingsCanadian English Ratings Chart Canadian Ratings ENG+ General Not recommended for young Canadian French Ratings ChartCanadian Ratings FRN Programming is not suitable for childrenSET Program Timer CursorVideo Input Sensor Mode Closed CaptionDisplay ChannelContrast Brightness Color Tint Sharpness Reset VideoPerfect Picture Advanced SettingsColor Temperature Auto ColorTreble AudioBass BalancePerfect Volume MTS ModeAuto Noise Cancel Internal SpeakersTheater Theater ModesTechnology SurroundSurround OFF Care of Your Hitachi Projection TV Your Remote Control Do notReception Problems Ignition NoiseSymptoms Useful Info43FDX20B 53FDX20B InputsOutputs 53SDX20BBHitachi Home Electronics DivisionDigital Media Division Page QR52482