
Rear Panel Jacks
Use the rear panel jacks to connect components such as a VCR. You can connect different components such as VCRs,
Œ ANTENNA terminals
Two independent cables or antennas can be connected to these terminals. Use “Cable IN” and “Air IN” terminals to receive a signal from VHF/UHF antennas or your cable system. Use the “Cable OUT” terminal to send the signal being received by the “Cable IN” terminal out to another component (such as a Cable
´Component1, 2 jacks (Y, PB, PR, L, R)
Use these jacks to connect the component video/audio signals from a DVD player or a
ˇ VIDEO/AUDIO OUTPUT jacks
Sends video/audio signal from the TV to an external source, such as a VCR.
These jacks are available only in RF, Video and
¨
Connects an
ˆ VIDEO/AUDIO INPUT jacks
Connect video/audio signals from external sources, such as VCR or DVD players. (Refer to page 26)
ØDVI (Digital Visual Interface) AUDIO INPUT jacks
Connect to the digital audio output jacks of a device with DVI output. (Refer to page 27)
∏ DIGITAL AUDIO OUT(OPTICAL) jack Connect to a Digital Audio Component. (Refer to page 29)
” Anynet
Please refer to the Anynet Owner’s Instruction.
’HDMI (High Definition Multimedia Interface)/ DVI
INPUT jack
Connect to the HDMI jack of a device with HDMI output.
Connect to the digital video output jack for device with DVI output. (Refer to page 27~28)
˝CableCARDTM
Insert the CableCARD into the slot. (Refer to page 24)
Ô SERVICE
This jack is for software upgrades.