Mitsubishi Electronics WD-52725, WD-62525, WD-52525, WD-62725 Appendix F Cleaning and Service

Page 92

Appendix F: Cleaning and Service

IMPORTANT

DO NOT use any kind of abrasive cleaner on the surface of the TV screen or Diamond Shield™.

Cleaning

Normally, light dusting with a dry, non-scratching duster will keep your TV clean. If cleaning beyond this is needed, please use the following guidelines:

First, turn off the TV and unplug the power cord from the power outlet.

Top and Sides of the TV:

Gently wipe down your TV with a soft, non-abrasive cloth such as cotton flannel or a clean cloth diaper, lightly moistened with water. Dry with a second dry, soft, non-abrasive cloth.

For oily dirt, add a few drops of mild liquid detergent, such as dishwashing detergent to the water used to moisten the cloth. Rinse with a second cloth moistened only with water. Dry with a third dry, soft, non-abrasive cloth.

Diamond Shield™:

• Clean with a soft non-abrasive cloth moistened with water only.

Screen behind the Diamond Shield:

Follow the instructions for the top and sides, however, wipe gently in an up and down motion, following the grooves in the screen.

Clean the entire screen evenly, not just sections of the screen.

Do not allow liquid to drip down the grooves of the screen as some liquid may enter the TV between the screen and the screen frame.

You may purchase Mitsubishi Screen Cleaner, part number CLEANER-VSS, by calling (800) 553-7278.

General Cleaning Warnings:

DO NOT allow liquid to enter the TV through the ventilation slots or any crevice.

DO NOT use any strong or abrasive cleaners as these can scratch the surfaces.

DO NOT use any cleaners with ammonia, bleach, alcohol, benzine, or thinners as these can dull the surfaces.

DO NOT spray liquids or cleaners directly on the TV’s surfaces.

DO NOT scrub or rub the TV harshly. Wipe it gently.

Service

If you are unable to correct a problem with your TV, consult your Mitsubishi dealer or a Mitsubishi Authorized Warranty Service Center.

DO NOT adjust any controls other than those described in this Owner’s Guide.

DO NOT remove the protective back cover of your TV.

Menus not described and shown in this owner’s guide are designed for Factory use and for Authorized Service Personnel. Damage caused to the TV by non-authorized changes or changes to these menus made by non- authorized persons are not covered under warranty.

92

Image 92
Contents Owner’s Guide Stand Requirement FCC Declaration of Conformity Contents TV Menu Screen Operations Ieee 1394 Devices and NetCommand Controlled RecordingsSpecial Features Important Safeguards Important Safeguards Our Thanks Mitsubishi Digital Electronics America, IncBack Panel TV Accessories Special Features Front Control PanelTelevision Overview TV Accessories Special FeaturesSystem Reset IndicatorsReset Front Control PanelInput Front Panel Inputs and Media Card SlotsMedia Card Slots and Ieee 1394 Input/Output Back Panel Component-1, -2 InputsCableCARD Slot Input-1, -2 Monitor OutputIR Emitter-NetCommand PC Input and AudioDTV Link/IEEE1394 DVI Analog AudioConnecting Connecting External Devices & NetCommand Setup ChartConnecting a Wall Outlet Cable or Cable Box Wall Outlet CableUsing a CableCARD CableCARD TechnologyConnecting a Lead Antenna or Separate UHF and VHF Antenna Separate UHF and VHF AntennaFor antennas with twin flat lead For cable or antenna with coaxial leadConnecting a VCR to an Antenna or Wall Outlet Cable Connecting VCR Video and Audio to a Cable Box Cable Box Back panelConnecting an A/V receiver Connecting a DVD Player with Component DTV Connectors and Adaptors DTV Receiver with Component VideoDTV Receiver to TV Back Panel Connecting a DTV Receiver with RGB, HV VideoDTV Receiver with RGB, HV Video Link Control RS-232C Connection LinkConnecting the IR Emitter NetCommand Quadruple IR Emitter cable is included with the TVConnecting Compatible Ieee 1394 Devices When Connecting Ieee 1394 DevicesDigital Video Signals Digital Audio SignalsPin Style vs -Pin Style Connectors Connection StylesDirect Device-To-Device Style Hub Connection StyleConnecting Helpful Hints NetCommand Setup and Editing Using the Remote Control with NetCommand NetCommand Pre-Memorized DevicesRemote Control Functions Overview OverviewRemote Control FunctionsOperation and Care, Sleep Timer For Best Results from the Remote ControlInstalling the Batteries Setting the Sleep TimerNetCommand Setup On Screen Buttons Remote Control Buttons 3D Graphical Menu SystemNetCommand Initial Setup NetCommand Information ScreenDevice Setup Screen Welcome ScreenReview Screen Review screenReceiver Inputs Edit NetCommand, Add an A/V ReceiverReceiver Screen Receiver Input Learn Screen Receiver Learn ScreenName Screen Monitor Out to AVR ScreenAdd Screen Edit NetCommand, Add DevicesEdit NetCommand Screen Device Learn Screen Edit NetCommand Add DevicesDevice Screen Device Advanced Learn Screen Connection for Device ScreenVCR for Recordings Screen RF Connection for Cable ScreenInput-DTV Connection Screen IR Code for Device ScreenDelete Device Screen Edit NetCommand, Change or Delete Devices, Finish ScreenChange Device Screen Ieee 1394 Devices NetCommand Controlled Recordings NetCommand Controlled RecordingsDevice Selection Menu Disc Search Track List Screen PC ViewingIeee 1394 Devices and NetCommand Control Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device ScreenIeee 1394 Device Type Screen Connection ScreenPIP Device Selection Menu Power On/Off DevicesDevice Selection Menu Using the Device Menu Button to Display Menus Device MenuIR Controlled Devices CableCARD MenuUsing the Guide Button to Display ChannelView and Menus Guide ButtonDevices 1394 or IR Controlled ChannelViewRecording Now Record To SetupTime-Delayed Recording Cancel Current Recordings Record List ScreenCopy-Protected Material Restrictions for Traditional VCRsNetCommand Controlled Peer-to-Peer Connections What is a Peer-to-Peer Connection?Setting up a Peer-to-Peer Connection Canceling a Current Peer-to-Peer ConnectionDirect VCR Recording from an Antenna or Cable Source Disc SearchPC Viewing PC InputMediaCommand and Media Card Playback Media Card SlotsInserting a media card Don’t pull the media card out while it is playingMedia Command and Media Card Playback TV Menu Screen Operations Main menu, Setup selected Main Menu ChoicesSetup Menu NetCommand Menu Antenna Menu MemorizePrefer Digital ChannelAntenna Menu, SuperQuickView SQV SQV SuperQuickViewTime Menu Captions Menu Analog and Digital Captions Captions Menu, Customizing Digital Settings Chip Lock Menu Passcode ChipEntry Chip Start Time and V-Chip Stop TimeChip Signal Information Content CategoriesChip Lock Menu V-Chip Definitions TV RatingsFront Button Lock Chip Lock MenuLock By Time AudioVideo Menu Setting Descriptions Audio Analog and Digital Audio SettingAnalog Only Audio Settings Digital Only Audio SettingsFor a Currently Viewed PC Setting Descriptions VideoVideo Settings Operation of PIP and POP Warranty IndexDVD Definitions Signals and Formats DefinitionsDisplay Formats Original Signal TV Display FormatsPC Display Formats Device Control with Net Command NetCommand Compatible Traditional Devices AnalogWhen an Ieee 1394 Device is Viewed or Played Ieee 1394 DevicesBypassing Front Button Lock Appendix a Bypassing the V-Chip LockBypassing the V-Chip Lock This page intentionally blank Inputs Appendix B SpecificationsTV Specifications Outputs Appendix CRemote Control Programming Codes Programming the Remote to Control NetCommand A/V ProductsAppendix C Remote Control Programming Codes DVD PlayersCable Boxes and Satellite Receivers ReceiversMitsubishi A/V Receivers Mitsubishi CD Players Not all functions for all modelsAppendix D On Screen Information Displays Appendix E NetCommand Specialized Device Keys Screen Remote Checkbox NameAppendix F Cleaning and Service To Install the Diamond Shield Appendix G Diamond Shield RemovalTo Remove the Diamond Shield For further assistance, call 800Appendix H Filter Cleaning Replace the lamp cartridgeAppendix H Lamp Cartridge Replacement Lamp LifeReplacing the Lamp Cartridge Troubleshooting Problem Possible SolutionTroubleshooting Troubleshooting 100 Using The System Reset Button 101Additional Information 102Index 103104 Icon Order, Viewing, Changing 64 IEEE1394Mitsubishi TV Software 105Mitsubishi DLP Projection Television Limited Warranty 106This Warranty does not Cover 107MDEAservice@mdea.com Website