Mitsubishi Electronics S290U user manual Signal, Clamp Position

5 SIGNAL
HORIZ. POSITION .... Use to adjust the horizontal position of the image.
				Opt
VERT. POSITION ..... Use to adjust the vertical position of the image.
FINE SYNC. ....... Use to synchronize the projector with PC input signals so	SIGNAL
that the image is not blurred.			HORIZ. POSITION		0
TRACKING ......... Use to avoid image noise such as wide stripes.			VERT. POSITION		0
COMPUTER INPUT .... The unit adjusts itself automatically when connected to			FINE SYNC.		0
			TRACKING		0
either DVD players with a component video output
			COMPUTER INPUT			RGB
terminal (YCBCR or YPBPR) or equipment with HDTV
		R G B
			USER
signal output capabilities. In cases where the unit is
connected to equipment that include an RGB output terminal and which output HDTV

signals, adjust the unit to RGB mode.

•In case of the HDTV, you cannot adjust the horizontal position and the vertical position of the image.

ENGLISH

6 SIGNAL - USER (Normally, there is no need for adjustments.)

HOLD BEGIN /

HOLD END ...... Adjusts the image when curving near the top.

CLAMP POSITION/

CLAMP WIDTH ......... If you use something similar, the brighter colors of the

projected image may become blurred. In this case, adjust CLAMP POSITION or CLAMP WIDTH.

ANAMORPHIC ... Set to ON when displaying DVD discs which are recorded as squeezed images (in right and left direction).

USER

HOLD BEGIN	1
HOLD END	1
CLAMP POSITION	0
CLAMP WIDTH	0
ANAMORPHIC	ON

EN – 17