
Using the Favorite Channel Key
Your One For All ® Easy 4 is equipped with a favorite channel key (FAV CH). You can set up the FAV CH key with a list of up to 10 of your favorite channels for either your TV,VCR, Cable Box, Satellite or DSS. Please note, the FAV CH key can only be set up for one device key (TV, VCR/LD or CBL/SAT) at a time. You cannot set up a favorite channel list for another device key until you have cleared the FAV CH key of your original list.
1Press the device key (TV, VCR/LD, or CBL/ SAT) for the home entertainment
TV | component that will contain your |
| favorite channel list. |
VCR/LD |
|
CBL/SAT
2Press and hold SETUP until One For All ® Easy 4’s red light blinks twice. Release
SETUP | SETUP and press |
|
9 - 9 - 6
Troubleshooting
Problem | Solution |
Red light not blinking | Replace the batteries with four (4) |
when you press a key? | new AAA alkaline batteries. |
|
|
The red light blinks | Make sure you are aiming your |
when you press a key | One For All ® Easy 4 at your home |
but you receive no | entertainment component and |
response from your | that you are within 15 feet of the |
home entertainment | component you are trying to |
component ? | operate before using your |
| remote. |
|
|
The One For All ® Easy | Try all the codes listed for your |
4 does not operate | home entertainment component |
your home | in the |
entertainment | Many |
component or is not | partial functionality, however, only |
performing | one |
commands properly? | home entertainment component |
| properly. Make sure that all of the |
| components you are setting up |
| are able to be operated with an |
| infrared remote control. |
|
|
Problems program- | Use the VCR |
ming a TV/VCR | brand. Some combo units may |
combo? | require both a TV code to control |
| volume and a VCR code for full |
| operation. |
One For All ® PRODUCTS
Limited Warranty
One For All(“OFA”) warrants, to the original purchaser only, that this product will be free from defects in materials and workmanship, under normal use, for ninety (90) days from the date of original purchase.
This warranty does not cover damage or failures caused by products or services not supplied by OFA, or which result from accident, misuse, abuse, neglect, mishandling, misapplication, faulty installation,
There are no express warranties except as listed above. OFA SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF WARRANTY. ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE WARRANTY PERIOD SET FORTH ABOVE. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
To obtain warranty service for a defective product during the warranty period,please return the product,preferably in the original carton, along with your purchase receipt, to the store of original purchase. A note detailing the complaint would be helpful. The store, at its option, will replace or repair this product if found to be defective.
3
SETUP
4
SETUP
Enter the channel number of the first channel you would like to add to your favorite channel list. Then press SETUP.
•If you are entering a single digit channel number, you must press 0 first.
•If you are entering a channel that is three digits long, such as 103, you do not have to press SETUP after you have entered the channel number.
•If your original remote control required you to use an ENTER key to change channels, press ENTER instead of SETUP after entering your channel number. For example, if you want to add TV channel “4” to your favorite channel list, you would: Press TV, then press and hold SETUP until the One For All ® Easy 4’s red light blinks twice, then release SETUP and press
Continue adding your favorite channels, up to 10 channels. Once you have finished, press and hold SETUP until the One For All ® Easy 4’s red light blinks twice.
VCR not recording? | As a safety feature on the One | |
|
| For All ® Easy 4, you must press the |
|
| REC key twice. |
|
|
|
No volume when in | Press and hold SETUP until the One | |
the Cable mode or | For All ® Easy 4's red light blinks | |
when operating a | twice. Release SETUP and enter | |
second TV or TV/VCR | ||
combination? |
| |
|
|
|
Channel +/- and | Due to RCA design | |
RECALL not working for | only the original remote control | |
your RCA TV? | will operate these functions. | |
|
| However, using the FAV CH key will |
|
| allow you to run through a list of |
|
| up to 10 of your favorite channels. |
|
| |
Problems changing | If your original remote control | |
channels? | required a ENTER keystroke when | |
|
| changing channels, press the |
|
| ENTER key on the One For All ® |
|
| Easy 4 after you enter the |
|
| channel number. |
|
|
|
Keypad scrambled? | Press and hold SETUP until the | |
|
| One For All ® Easy 4's red light |
|
| blinks twice. Release SETUP and |
|
| enter |
|
|
|
World Wide Web: http://www.oneforall.com
One For All
One For All® is a trademark of Universal Electronics Inc.
Copyright 1996 by Universal Electronics Inc. No part of this publication may be reproduced, transmitted, transcribed, stored in any retrieval system, or translated to any language, in any form or by any means, electronic, mechanical, magnetic, optical, manual, or otherwise, without the prior written permission of Universal Electronics Inc.
This One For All® product is designed for compatibility in North America excluding Mexico.
5/98
5To scan through your favorite channel
FAV CH list, press FAV CH. Your One For All ® Easy 4 will automatically scan through your
favorite channel list, stopping at each channel for three seconds.
6To stop at one of your favorite channels, press any key on the One For All ® Easy 4.
To clear an entire favorite channel list from the FAV CH key:
1Press and hold SETUP until the One For All ® Easy 4’s red light blinks twice, then
SETUP | release SETUP. |
2Press 9-9-6, then press and hold SETUP
SETUP