Installing the Batteries

Your ONE FOR ALL 1 Remote needs 2 new "AA/LR6" Alkaline batteries.

1Remove the battery cover from the back of your ONE FOR ALL 1 by pressing down on the arrow on the battery cover and sliding it back- wards.

2Match the batteries to the + and – marks inside the battery case, then insert the batteries.

3Slide the battery cover back into place until it clicks. Make sure the battery cover is secure.

Important notes:

-In order to avoid having to re-program your ONE FOR ALL 1 after you remove the batteries, you will need to insert new batteries within 5 minutes. Also it is recommended that you do not use rechargeable batteries.

-On the inside of the battery compartment door you will find a label on which to write your Set-Up Codes for future reference. This you will do after setting up your ONE FOR ALL 1 remote for your devices.

Features and Functions

Please refer to the picture of the ONE FOR ALL 1 Remote Control on Page 3.

1Power Key:

The Power key controls the same function as it did on your original remote.

2LED:

During the use of your ONE FOR ALL 1, the LED will flash red every- time you press a key.

3Number Keys:

The Number keys (0-9, -/--(10), AV (20)) provide the functions just like your original remote, such as the direct access to programme/channel selection. If your original remote uses a 10 key, this function can be found by pressing the -/-- key. If your original remote uses a 20 key, this function can be found by pressing the AV key.

4Menu Key:

The Menu key controls the same function as it did on your original remote control.

5Magic Key:

The Magic key is used to set-up your ONE FOR ALL 1 Remote Control and to access special functions.

Exit Key:

The Exit key will exit the Menu.

Menu Navigator:

The Menu Navigator is a miniature joystick. The movement of the navigator up, down, left and right operates the same functions as the up, down, left and right keys of your original remote. By pressing the Menu Navigator, it will operate the same function as the OK/Select key on your original remote control. These keys will allow you to navigate up, down, left and right through the menu of your device.