dbx Pro AFS 224 user manual Electromagnetic Compatibility

Page 3

IMPORTANT SAFETY INSTRUCTIONS

ELECTROMAGNETIC

COMPATIBILITY

This unit conforms to the Product Specifications noted on the Declaration of Conformity. Operation is subject to the following two conditions:

this device may not cause harmful interference, and

this device must accept any interfer- ence received, including interference that may cause undesired operation.

Operation of this unit within significant electromagnetic fields should be avoided.

use only shielded interconnecting cables.

U.K. MAINS PLUG WARNING

A molded mains plug that has been cut off from the cord is unsafe. Discard the mains plug at a suitable disposal facility. NEVER UNDER

ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET. Do not use the mains plug without the fuse cover in place. Replacement fuse covers can be obtained from your local retailer. Replacement fuses are 13 amps and MUST be ASTA approved to BS1362.

DECLARATION OF

CONFORMITY

Manufacturer’s Name:

dbx Professional Products

Manufacturer’s Address:

8760 S. Sandy Parkway

 

Sandy, Utah 84070, USA

declares that the product:

 

Product name:

dbx AFS 224

Note:

Product name may be suffixed by the

 

letters-EU.

Product option:

None

conforms to the following Product Specifications:

Safety:

IEC 60065 (1998)

EMC:

EN 55013 (1990)

 

EN 55020 (1991)

Supplementary Information:

The product herewith complies with the requirements of the Low Voltage Directive 72/23/EEC and the EMC Directive 89/336/EEC as amended by Directive 93/68/EEC.

Vice-President of Engineering

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

Date: June 9, 2003

European Contact: Your local dbx Sales and Service Office or

Harman Music Group

8760 South Sandy Parkway

Sandy, Utah

84070 USA

Ph: (801) 566-8800

Fax: (801) 568-7583

Image 3
Contents AFS Important Safety Instructions Electromagnetic Compatibility AFS Table of ContentsAFS 224 Operation Introduction Defining the AFSAFS 224 Advantage Warranty Service Contact InfoOperation Installation / Connections Installation RecommendationsBasic Connection of the AFS Rear and Front Panels Rear PanelFront Panel User Setup Setting Gain StructureLift Time User Setup Operation Setup ModeUsing Fixed mode Using Live Mode Using Types in Fixed modeRinging out a system Other Functions Clearing Filters Fixed and LiveApplication Guide ApplicationsApplication 1 Insert On the Microphone Channel Output to Speaker Application 3 Insert on the Subgroups of a Mixer Applications GuideApplication 4- Connected Inline with the Outputs of a Mixer Block diagram Operation Block DiagramSpecifications Harman International Company