1.8Installation
To setup Avenview
1.Connect your HDMI/DVI source (such as a
2.Connect your HDMI/DVI display (such as a LCD TV) to the receiving unit
3.Connect your
4.Make sure
5.Plug in 5V DC power cord to the power jack of the receiving unit
6.Plug in 5V DC power cord to the power jack of the transmitting unit
If a flickering or a blinking image is seen, try to adjust the rotational switch to improve the cable skew. 0 stands for the strongest EQ while 7 stands for the weakest. Try adjusting the EQ from 7 to 0
1.9EDID Learning
To learn EDID from the monitor/TV following these steps
1.Turn on
2.Turn the Mode of
3.Use a HDMI cable to connect
4.Turn the Mode of
5.Connect
The most important thing is don’t let the rotary arrow pass through 6 which will erase the EDID just learned and restore to default EDID.
www.avenview.com | 8 |
|
|