EverFocus EDVR 9D1, EDVR 4D1, RS232, EDVR 16D1 To set DVR for Internet Connection through router

￿To access the DVR from a computer simply open Internet Explorer and in the address bar type: http:// (IP address of the DVR)

￿Note: The DVR’s IP address will only work at the location of the DVR. To connect from a different location over the Internet, see below.

To set DVR for Internet Connection through router

￿The next step is to open ports within your router. Log into the router using a PC and open the following ports.

oECOR Ports to open: 80, 1600

oIf your Internet service provider blocks port 80, you can change it to a different port in the

DVR’s Network Menu Setup.

oIf you are using a Linksys or D-Link router, see Chapter 9 for basic support on setting up ports. For any other router, you will need to contact the manufacturer for support.

￿To access the DVR from a computer simply open Internet Explorer and in the address bar type: http:// (the IP address given by your internet service provider)

￿Note: If you changed to a different port other than 80, you will need to include this at the end of the IP address

Example: http://70.20.70.20:8100

￿If you have a Dynamic IP address and have opened the ports, go to the next chapter to setup DDNS.

84