SVAT Electronics CV0204DVR instruction manual Dhcp

SVAT ELECTRONICS

Now You Can See

6.4.3.2 DHCP

The “DHCP” is automatically set as the default network setting of the Network DVR. When a Network DVR is connected into the LAN, it will issue DHCP packets to request an IP address that is dynamically assigned by the DHCP server. If it is unable to get a DHCP address, the Network DVR will assign a default IP address such as “169.254.1.13”.

6.4.3.3CONNECT TO ADSL BY PPPoE MODE To setup follow the steps below:

1.After setup, rebooting enables automatic connection to ADSL.

2.Enter the “Username” and “Password” fields with the account and password provided by the ISP.

3.If item “Send mail after connected” is selected, the mail will be automatically sent when connected to the ISP.

4.Click “OK” button to save the settings.

Note: In order to activate the function, it is necessary to reboot the device after the setup.

ADSL Setting Display

If the Network DVR and ADSL modem are connected by a hub, the user can select “Dial On Power Up” to perform the connect operation. However, if the Network DVR and ADSL modem are connected directly, then please note the following steps below.

1.Power off Network DVR.

2.Connect Network DVR directly to the ADSL modem (using RJ-45 Ethernet port).

3.Power-up Network DVR.

4.Network DVR will start dialing.

5.Once connected, mail the IP address information to the preset e-mail address.

6.After 10 times of connection failure, it aborts the operation and the user can reconnect it by LAN to find the cause.

CV0204DVR 38