SanDisk Video Memory Card Recorder warranty Read these Instructions, Connecting V-Mate

Read these Instructions.

•Keep these Instructions.

•Heed all Warnings.

•Follow all instructions.

•Clean only with a damp cloth (unplug the power adapter before cleaning).

•Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

•Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

•Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

•Only use attachments/accessories specified by the manufacturer.

•Unplug this apparatus during lightning storms or when unused for long periods of time.

•Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

•Do not use near water (e.g. sink, bathtub, swimming pool, etc.).

Warning:

Connecting V-Mate

1.Connect one audio/video cable to the composite video output and audio left/right output of an analog video source (e.g. cable/satellite box, camcorder, VCR or DVD player). The yellow plug should connect to Video Out, the red plug should connect to Audio Out (R), and the white plug should connect to Audio Out (L). Connect the 3.5 mm connector on the other side of the cable to the AV In connection on the back of the V-Mate.

2.If you are using a cable/satellite/terrestrial receiver box or VCR, connect the 3.5 mm connector on the IR Emitter cable to the IR Emitter connector on the back of the V-Mate. The IR emitter will automatically power on/off and select channels at cable/ satellite/terrestrial receiver box or VCR during a scheduled recording. Remove the protective layer from IR emitter and stick the IR emitter next to the remote sensor of the cable/satellite/terrestrial receiver box or VCR. When attaching the IR emitter to the video source box, make sure to cover only a part of the IR Receiver window so that it will not block the IR signal coming from the remote control. To find the remote sensor on the video source box, consult its manual for more information.

Video Source

Box (front)

IR Emitter