Philips (PSS-2000BR/SS) Stand Anchoring Procedures, Cable Management, Anchor stand follows

Page 7

Instruction Manual

STAND ANCHORING PROCEDURES

NOTE: Due to the wide variety of anchoring options, hard- ware is not provided.

Anchor stand follows:

1.Select a suitable location for anchoring, allowing for room for swivel and access for cabling.

2.Using the template provided, drill anchoring holes for the four 1/4-20 X 1/2” tapped holes (see Figure 7).

3.If routing cables through mounting surface, Use the tem- plate provided and drill the cable access hole in the mounting surface.

CABLE MANAGEMENT

Install cables as follows:

1.Attach cabling to flat panel display.

2.Route cables in one of three ways:

a.down the back of the display (open),

b.through the center post of the stand and out the bot- tom of the stand in the back,

c.through the center post of the stand and through a hole in the mounting surface.

Swivel Stand

1/4-20 X 1/2” Tapped holes

Figure 7. Anchoring Hole Locations

6

Page 6 Page 7
Image 7
Page 6 Page 7
Contents Before YOU Begin Plasma Swivel Stand PSS-2000BR/SSContents Tools Required for InstallationParts Inspect Parts Before AssemblyStand Assembly Procedures Display Preparation ProceduresFor displays Taller Than 30 Inches Stand Adjustment Procedures Display Installation ProceduresAnchor stand follows Stand Anchoring ProceduresInstall cables as follows Cable Management
Top Page Image Contents