Philips Hooking Up the TV/DVD cont’d, VHF/UHF Antenna Not supplied Rod Antenna or Not supplied

Page 8

8 Hooking Up the TV/DVD (cont’d)

2C.

Hooking Up Your TV/DVD with an Indoor Rod Antenna

or a Combined UHF/VHF Antenna

Push the stem of the antenna into the anten- na hole on the top of the TV/DVD. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/DVD.

Extend the rod antenna and adjust its length, direction, and angle for the clearest picture.

2D.

Hooking Up Your TV/DVD to Another Video Source

(VCR or Camcorder)

VHF/UHF Antenna

(Not supplied)

Rod Antenna OR (Not supplied)

ANT.

Connect the antenna wire to the ANT(enna) jack on the TV/DVD.

You may need this connection if you want to view videotapes on the TV/DVD.

When viewing material from other equipment, press the SELECT button repeatedly until VIDEO appears in the top right corner of the TV/DVD screen. That indicates that the TV/DVD is in VIDEO mode and is receiving the programming from the equipment that is connected to the AUDIO and VIDEO In jacks on the front of the TV/DVD.

•If the VCR or camcorder only has one audio out jack, use the white audio cable to connect it to the white AUDIO L (left) In jack on the front of the TV/DVD.

Connect the red and white audio cables to the

AUDIO OUT jacks on the VCR and to the

AUDIO In jacks on the front of the TV/DVD.

3CH IN 4CH

AUDIO VIDEO

OUT ANT.

INOUT

	3CH	IN
	4CH	IN
	4CH
AUDIO	VIDEO	ANT.
	OUT	ANT.

INOUT

VIDEO L-AUDIO-R

Connect the yellow video cable to the VIDEO OUT jack on the VCR and to the VIDEO In jack on the front of the TV/DVD.

3

Unless you want to connect the TV/DVD to a stereo or decoder, you are finished. Connect the TV/DVD (and Cable Box, VCR, etc.) to a power source. Go to page 11 to set up your remote control, then go to page 17 to turn on the TV/DVD. To connect more equipment to your TV/DVD, refer to pages 9-10.

Image 8

Contents CDV19BPH Dear Philips product owner For Customer UseThis bolt of lightning indi- cates uninsulated material Model No Serial NoSafety Information Table of Contents Introduction Playable Discs Region CodesColor Systems Unacceptable DiscsHooking Up the TV/DVD Connect a Cable signal or an antenna to the ANTenna JackSystem Installer Hooking Up the TV/DVD cont’d VHF/UHF Antenna Not supplied Rod Antenna or Not suppliedOptional Connections Audio cables to Audio in jacks on stereoAudio cables to Jacks on backConnecting to a Dolby Digital Decoder or DTS Decoder Optional Connections cont’dRemote Control Putting Batteries in the Remote ControlUsing the Remote Control Recycling Guidelines/Battery SafetyRemote Control cont’d Power ButtonPress to turn the power on and off Number Buttons TV modeRemote Control cont’d VOL. Volume o / p Button DVD ButtonCH. Channel o / p Button Press to scan through the available TV channelsFront Panel Antenna Hole AC Power CordRear Panel TV/DVD is shipped in TV mode. If necessary, press Connect the power cord to a standard AC outletPress the Power button to turn on the TV/DVD Press the Menu button Press the K or L button to select LanguageAppear inside the parentheses Setting Up TV Channels TV menu appears on the screenAdding or Deleting Channels Press the K or L button to select Channel SET. ThenPress the B button Repeat steps 4-5 to add or delete other channelsChannel number appears in the upper right corner Screen Adjust the picture controls for a natural imagePress the Select button repeatedly so that TV or a Press the B or s button to select C1, C2, T1, T2, or OFF Closed Captioning TV modePress the K or L button to select Caption Within 10 seconds, press the B or s button to set Game Picture AdjustmentPress the B button to access the Picture menu Chip Setup Press the K or L button to select V-CHIP SET UPPress the K or L button to select a rating, then press Chip Setup cont’dPress the B button to see the TV ratings Movie Ratings Sleep Timer SleepPlaying a Disc Press the Stop button to stop playbackDisc Menus Using the DVD MenusUsing the Title Menu Pausing Playback Pausing PlaybackWhere playback stopped Memory OnStep by Step Playback Slow MotionPlay will appear briefly on the screen Press the SLOW/FWD button. Slow motion playback willFast Forward/Reverse Search DX2Starting Playback at a Specific Track Using the Number Buttons to Select a TrackTrack Playback Using the Number Buttons to Select a Title/Chapter When playback is stopped, press the Number buttons toTitle/Chapter Playback Starting Playback at a Specific Title/ChapterSpecific Time Playback Starting Playback at a Specific Disc TimeUse the Number buttons to enter the Disc time at which You want playback to beginRepeat Playback Repeat playback is not available with some DVDs Programmed Playback Random Playback Press the DVD button Audio CD Sound ModeDVD Language Subtitle menu will disappear after about 15 seconds TV/DVD allows you to select a language for subtitlesMenu will appear on the screen Camera Angles Parental Lock Password SETUP/LOCK menu will appearPress the Number buttons to enter the 4-digit password Press the Number 4 button to select LockPress the Number 1 button to select Level Press the Number buttons to enter your 4-digit passwordParental Lock Levels No display Accessing the Status DisplayStatus Display Press the Number 3 button to select Audio Audio SettingsGo to to change one of the Digital OUT settings Audio Settings cont’d Press the Setup button to remove the DVD Player menuLanguage Settings Press the Number 1 button to select LanguagePress the Setup button to remove the menu Insert a disc Language Settings cont’dPress a Number button to select a setting Language Country Code 5165Press the Number 2 button to select Video Video SettingsSetup screen will appear Other Menu Settings Press the Setup button. The setup screen will appearCare and Maintenance Cleaning the TV/DVDCleaning a Disc Checking the LaserHelpful Hints Helpful Hints cont’d Glossary Tuning System Signal-to-Noise RatioOperating Temperature Power RequirementsLimited Warranty Model # Serial #Power Setting12-14 HookupsSupplied Accessories