Philips DVP3040/05 Using Component Video jacks Y Pb Pr, Using an accessory RF modulator

Connections
English
			RF coaxial cable to TV
			2
	COMPONENT			Back of RF Modulator
S-VIDEO	VIDEO IN
					(example only)
IN	V (Pr/Cr)	AUDIO
		IN
	U (Pb/Cb)		INT IN	TO TV VIDEO	AUDIO IN
VIDEO IN				IN	R	L
	Y
						CH3	CH4
1		2	Antenna or
			Cable TV signal			1

IMPORTANT!

–The progressive scan video quality is only possible when using Y Pb Pr and a progressive scan TV is required.

Using Component Video jacks (Y Pb Pr)

1Use the component video cables (red/ blue/green) to connect the DVD system’s Y Pb Pr jacks to the corresponding Component video input jacks (or labeled as Y Pb Pr) on the TV (cable not supplied).

2To hear the sound of this DVD Player through your TV, use the audio cables (white/red) to connect AUDIO OUT (L/ R) jacks of the DVD Player to the corresponding AUDIO IN jacks on the TV (cable not supplied).

3Proceed to page 18 for detailed Progressive Scan set up.

IMPORTANT!

–If your TV only has a single Antenna In jack (or labeled as 75 ohm or RF In,) you will need an RF modulator in order to view the DVD playback on the TV. See your electronics retailer or contact Philips for details on RF modulator availability and operations.

Using an accessory RF modulator

1Use the composite video cable (yellow) to connect the DVD Player’s CVBS jack to the video input jack on the RF modulator.

2Use the RF coaxial cable (not supplied) to connect the RF modulator to your TV’s RF jack.

12

001-043 DVP3040_Eng_02_RC4 12 05/06/06, 2:13 PM