Philips DVP3256K/93 Analog Output, Lt/Rt, Stereo, Surr, Multi Channel, Digital Audio Setup, 96 K

Setup Menu Options (continued)

English

Audio Setup Page (underlined options are the factory default settings)

Analog Output	This setting is only required if you have connected the audio
	output of this unit to a stereo device, multi channel audio system
	or TV using the analog output jack.
	{ LT/RT }	–	The connected device has a built-in
			Dolby Pro Logic decoder. It can deliver
			the surround sound through the two
	{ Stereo }		speakers.
		–	The connected device can only output
	{ V SURR }		stereo audio through two speakers.
		–	For virtual surround sound effects.
	{ Multi Channel }	–	The connected device can output 5.1
			channel sound.
Digital Audio Setup	This setting is only required if you have connected the audio
	output of this unit to an amplifier/receiver using the digital
	output jack.
	{ Digital Output }	–	{ SPDIF Off }
			Disable digital audio output. Select this
			if you are using the analog audio jacks
			to connect this unit to a TV or Stereo
			system.
			{ All }
			The connected device supports multi-
			channel audio formats. The digital audio
			format will be output as on disc.
			{ PCM Only }
			The connected device does not support
			multi-channel formats. All audio signals
			are downmixed to PCM format
			(2-channel).
	{ LPCM Output }	–	{ 48 K }
			Select this to play disc recorded at
			sampling rate of 48 kHz.

{ 96 K }

Enable 96 kHz output on digital audio if the amplifier/receiver is compatible with high sampling rate audio (88.2 / 96 kHz). However, if the sound output is distorted or there is no sound, change the setting to ‘48 K’.

Note: LPCM Output can only be selected when { PCM Only } is activated. The higher the sampling rate, the better the sound quality.

36

dvp3256K_93_eng1.indd 36 2008-03-27 1:57:44 PM