8 Additional information
Update software
For software updates, check the current software version of this product to compare with the latest software (if available) at the Philips website.
Caution
•Power supply must not be interrupted during software upgrade.
1Press SETUP.
2Select [Preferences] > [Version Info], and then press OK.
3Write down the file name, and then press SETUP to exit the menu.
4Visit www.philips.com/support to check for the latest software version, using the file name for this product.
5Refer to the upgrade instructions on the website for more information.
Note
•Disconnect the power cord for a few seconds and connect again to turn on the product.
Care
Caution
•Never use solvents such as benzene, thinner, cleaners available commercially, or
Clean discs
Wipe the disc with a micro fibre cleaning cloth from the centre to the edge in a straight line movement.
Specifications
Note
•Specification and design are subject to change without notice
USB
•Compatibility:
•Class support: UMS (USB Mass Storage Class)
Video
•Signal system: PAL / NTSC
•Composite video output: 1 Vpp ~ 75 ohm
•Component video output: 0.7 Vpp ~ 75 ohm Audio
•Analog stereo output
•Signal to noise ratio (1 kHz): > 90 dB
•Dynamic Range (1 kHz): > 80 dB
•Crosstalk (1 kHz): > 80 dB
•Distortion/noise: (1 kHz): > 70 dB
•MPEG MP3: MPEG Audio L3
Main unit
•Dimensions (w x h x d): 360 x 37 x 210 (mm)
•Net Weight: 1.45 kg
Power
•Power supply rating: 110 - 240V, 50/60HZ
•Power consumption: < 10 W
•Power consumption in standby mode: < 1 W Accessories supplied
•Remote control and batteries
•Audio/Video cables
•User Manual
Laser specification
•Type: Semiconductor laser InGaAIP (DVD), AIGaAs (CD)
•Wave length: 655 nm (DVD), 790 nm (CD)
•Output Power: 7.0 mW (DVD), 10.0 mW (VCD/CD)
•Beam divergence: 60 degrees
16EN