Philips DVP3888 user manual Audio setup, Audio OUT Front L/R

Setup

Audio setup

General	Analogue Output	Stereo
	Digital Audio
Video	HDMI Audio	On
	Audio Sync
Audio	Volume
	Sound Mode
Preference	Speaker Setup
	Night Mode	Off

[Analogue Output] - Adjust this setting for audio output through AUDIO OUT.

•[Stereo] - Compress multi-channel Dolby digital sound to stereophonic sound output through

AUDIO OUT FRONT L/R.

•[LT/RT] - Compress multi-channel Dolby digital sound to 2-channel surround sound output through AUDIO OUT FRONT L/R.

•[Multi Channel] - Enjoy Dolby digital sound output through AUDIO OUT 5.1 channels.

[Digital Audio] - Adjust this setting for audio output through COAXIAL/DIGITAL OUT.

•[Digital Output] - Select a type of digital output.

•[Off] - Disable digital output.

•[All] - Support multi-channel audio formats.

•[PCM Only] - Downmix to two-channel audio signal.

•[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.

Note

•[LPCM Output] setting is changeable only when [Digital Output] is set as [PCM Only].

•The higher the sampling rate, the better the sound quality.

[HDMI Audio] - Enable or disable the audio output through HDMI cable.

[Audio Sync] - Set a delay time for audio output when you play a video disc.

[Volume] - Set the default volume level.

[Sound Mode] - Select a preset sound effect.

[Speaker Setup] - Optimize the surround effect for the connected speaker system.

•[Front Speaker], [Center Speaker] and [Rear Speaker]

•Select [Large] when the speakers support the output of low frequency signal (lower than 120 Hz), otherwise select [Small].

•Select [Off] (This option is not available for [Front Speaker]) to mute the speaker(s).

•[Subwoofer] - Mute or unmute the subwoofer.

•[Speakers Volume] - Increase or decrease the volume level of each speaker.

•[Speakers Delay] - Set the delay time for each speaker.

18EN