Sony HCD-XGR60 specifications HCD-XGR6/XGR60, Flexible Circuit Board Repairing

HCD-XGR6/XGR60

MD (VIDEO) OUT:
(phono jacks)	voltage 250 mV
	impedance 1 kilohms
FRONT SPEAKER:	accepts impedance of 6 to

16ohms

*North American and Mexican models only

CD player section
System	Compact disc and digital
	audio system
Laser	Semiconductor laser
	(λ =795 nm), Emission
	duration: continuous
Frequency response	2 Hz – 20 kHz (± 0.5 dB)
Signal-to-noise ratio	More than 90 dB
Dynamic range	More than 90 dB
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength:	660 nm
Output level	–18 dBm
Tape player section
Recording system	4-track 2-channel stereo
Frequency response	40 – 13,000 Hz (± 3 dB),

using Sony TYPE I cassette

Tuner section

FM stereo, FM/AM superheterodyne tuner

FM tuner section
Tuning range
North American models:	87.5 – 108.0 MHz
	(100 kHz step)
Other models:	87.5 – 108.0 MHz
	(50 kHz step)
Antenna	FM lead antenna
Antenna terminals	75 ohms unbalanced
Intermediate frequency	10.7 MHz
AM tuner section
Tuning range
Pan- American models:	530 – 1,710 kHz
	(with the interval set at 10 kHz)
	531 – 1,710 kHz
	(with the interval set at 9 kHz)
Other models:	531 – 1,602 kHz
	(with the interval set at 9 kHz)
	530 – 1,710 kHz
	(with the interval set at 10 kHz)
Antenna	AM loop antenna
Antenna terminals	External antenna terminal
Intermediate frequency	450 kHz

General
Power requirements
North American models:	120 V AC, 60 Hz
Mexican model:	120 V AC, 60 Hz
Other models:	120 V, 220 V or 230 –
	240 V AC, 50/60 Hz
	Adjustable with voltage
	selector
Power consumption
U.S.A. models:
LBT-XGR6	240 watts
Other models:
LBT-XGR60	180 watts
Dimensions (w/h/d)	Approx. 355 x 425 x 451 mm
Mass :
LBT-XGR6	Approx. 13.0 kg
LBT-XGR60	Approx. 14.7 kg
Supplied accessories:	AM loop antenna (1)
	FM lead antenna (1)
	Speaker cords (2)
	Speaker pads (8)
	Remote commander (1)
	Batteries (2)

Design and specifications are subject to change without notice.

Notes on chip component replacement

•Never reuse a disconnected chip component.

•Notice that the minus side of a tantalum capacitor may be damaged by heat.

Flexible Circuit Board Repairing

•Keep the temperature of soldering iron around 270˚C during repairing.

•Do not touch the soldering iron on the same conductor of the circuit board (within 3 times).

•Be careful not to apply force on the conductor when soldering or unsoldering.

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the rear exterior.

2