General operation
Connecting the power supply
1Plug the female end of the power cable supplied into the Power connector on the rear of the player.
2Plug the male end of the cord into an AC outlet.
Turning on the power
¦Make sure that audio and video output has been connected to TV.
¦Choose the available AV mode and connect your TV set to our DVD player.
¦Press power on/off button on the front panel to turn on the player.
Loading discs
¦Press the OPEN/CLOSE button on the front player to open the disc tray.
¦Load your chosen disc in the tray, label side up (also when a double sided DVD is inserted). Make sure the disc is placed properly in the correct recess.
¦Gently push the tray, or press OPEN/CLOSE button to close the tray. Playback will start automatically.
NOTE:
–If your TV system is not align with your DVD player, the player might not work. If this happens, you can press the OPEN/CLOSE key to open the disc tray and press the ZOOM key on the remote control to enforce the player to adapt to your TV system.
Options between component video and S- Video
¦Ensure that the DVD player and television has been connected by an alternative cable.
¦In OPEN mode, press the SLOW BACKWARD key to choose an alternative setting depending on the video connection between the DVD player and television (refer to chapter [Video Connection] at page 11 for details) and the word “ CVBS+ SVIDEO” or “ YCbCr” appears on the TV screen.
¦The DVD player will execute to the corresponding setup automatically.
NOTE:
–If there is some image distortion, check if the video connection is corresponding with the operation on your remote control. If not, press the SLOW BACKWARD key again and repeat the above steps.
Remote control battery installation
¦Open the battery compartment cover.
¦Insert two batteries inside the battery compartment.
¦Close the cover.
CAUTION:
–Don’t mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.)
Remote control operation
¦Unless mentioned, all operations can be carried out with the remote control. Always point the remote control directly at the player, making sure there are no obstructions in the path of the infrared beam.
¦When there are corresponding keys in the front panel, they can also be used.
English
13