Installation
Using an accessory RF modulator
IMPORTANT!
–If your TV only has a single Antenna In jack (labeled as 75 ohm or RF In), you will need an RF modulator in order to view DVD playback on the TV. See your electronics retailer or contact Philips for details on RF modulator availability and operations.
ANT IN RF coaxial cable to TV
2
INT IN TO TV VIDEO | AUDIO IN | |
IN | R | L |
CH3 CH4
3
1
Step 4: Placing the set and speakers
1After finishing all rear connections, mount the detachable cover on the back of the set until hearing a click to avoid cable clutter.
2Align the side marked PRESS4 of the stand to the slots at the bottom of the set.
English
1Use a composite video cable
2Use an RF coaxial cable (not supplied) to connect ANTENNA OUT or TO TV jack on the RF modulator to the Antenna IN jack on the TV.
3Connect the Antenna or Cable TV service signal to the ANTENNA IN or RF IN jack on the RF modulator. (It may have been connected to your TV previously. Disconnect it from the TV.)
3Push the stand down into the slots until you hear a click.
4Place the set upright on the desktop with the support of the stand.
5Extend the bracket on the back of each front speaker so that the front speakers can stand firmly on the desktop.
6Place the subwoofer on the floor near an AC outlet.
Note:
– To remove the stand from the set, while pressing down PRESS4 , pull the stand out from the slots.
15