Amplifier Location and Mounting

The Soundstream Granite 110.2 amplifier employs highly efficient circuitry and a unique Chassisink TM design to maintain lower operating temperatures. When mounting the amplifier, it should be securely fastened to the vehicle, away from moisture, stray or moving objects, and major electrical components (electrical motors, fuel pumps, etc.). To provide adequate ventilation, mount the amplifier so that there are at least two inches of freely-circulating air above and to the sides of it.

Before mounting the amplifier, make certain the amplifier is configured correctly for your system.

BRIDGING/MONO

If used in dedicated mono, set the switch to the mono setting and follow the wiring diagram below.

If used in Mixed Mono, set the switch to the stereo position and follow the wiring diagram below.

XXX DIAGRAMS XXX

BASS EQUALIZATION

If the Granite 110.2 is being used to drive a subwoofer, you may want to activate the subwoofer equalization circuit by throwing the switch to the “XXX” position. Activating the circuit also engages a subsonic filter at 45 Hz. The subsonic filter is designed to remove the very low frequency bass information that may damage subwoofers.

CROSSOVER SETTINGS

The Granite 110.2 can be configured to operate full range (for a set of satellite speakers or coaxials), low pass (for subwoofers), or high pass (for satellites or coaxials while another amp driving the subwoofers).

XXXDIAGRAMS XXX

A. Using the amplifier as a template, mark the mounting surface.

B.Remove the amplifier and drill the holes.

C.Mount the amplifier to the surface using the provided hardware.