Basic Operations
Switching the system on/off
●Press
➜ “HELLO” is displayed briefly.The system will
switch to the last selected source.
●Press DISC, TUNER, USB or AUX on the remote.
➜ The system will switch to the selected source.
To switch the system to standby mode
●Press
Volume control
Turn VOLUME
➜”VOL XX” is displayed on the display panel. “XX” denotes the volume level.
To switch off the volume temporarily
●Press MUTE on the remote.
➜Playback will continue without sound and “MUTING” flashes.
●To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.
To listen through the headphone
●Connect the headphone plug to the n socket on the front panel.
➜The speakers will be muted.
Sound control
DBB, DSC and LOUDNESS sound features cannot be activated at the same time.
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
●Press DBB on the remote control to enable/ disable DBB feature.
➜ Some discs might be recorded in high modulation, which causes a distortion at high volume. If this occurs, switch off DBB or reduce the volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound equalizer setting.
●Press DSC on the remote control repeatedly to select: FLAT, POP, JAZZ, CLASSIC or ROCK.
LOUDNESS
LOUDNESS feature enables the system to automatically increase the treble and bass sound effect at low volume (the higher the volume, the lower the treble and bass increase).
●Press LOUDNESS on the remote to enable or disable LOUDNESS feature.
➜ icon appears/disappears after this feature is enabled/disabled.
Dimming the display screen
●Press DIM repeatedly to select different levels of brightness for the display screen.
Demonstration mode
The system has a demonstration mode that shows the various features offered by the system.
To activate the demonstration
●In standby mode, press 9 on the system to activate the demo mode.
➜ Demonstration will begin.
To deactivate the demonstration
●Press 9 on the system again. ➜ “DEMO OFF” is displayed.
Note:
–Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration will remain off until you activate it again.
English
19