NRefer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
OBattery usage CAUTION - To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit:
•Install all batteries correctly, + and - as marked on the unit.
•Do not mix old and new batteries.
•Do not mix alkaline, standard
•Remove batteries when the unit is not used for a long time.
•The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
•Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
PApparatus shall not be exposed to dripping or splashing.
QDo not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles).
RThis product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.
SWhere the MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
Class II equipment symbol
This symbol indicates that the unit has a double insulation system
Notice
Notice of compliance
This set complies with the FCC rules, Part 15 and with 21 CFR 1040.10. Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause undesired operation.
FCC rules
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.