Philips SBC RU 151 manual Instructions for use, Setting the remote control, Green LED remains lit

RU151.qxd 04-06-2004 16:51 Pagina 5

Instructions for use

Setting the remote control

This is only necessary if your TV does not respond to the RU151.

If that is the case, the RU151 does not recognize the brand and/or model of your TV and you need to program the remote control to do so.

The example below instructs you how to do this.

1Turn on the TV manually or use the original remote control. Tune in to channel 1.

2Look up the brand of your TV in the code list at the back of this manual. One or more five-figure codes are shown for each brand. Note the first code.

3Keep keys s and y on the RU151 pressed simultaneously for five seconds until the

green LED remains lit.

	+
	PROG
VOL	VOL
	+
	PROG

English

4 Then enter the code noted in step 2	+
using the remote control keys as follows:
	PROG
VOL	VOL
- PROG + for entering 1;	+
- VOL – for entering 2;	PROG
- VOL + for entering 3;
- PROG – for entering 4;
- Mute (s) + for entering 5.

–The green LED will now flash twice.

If the LED flashes once for an extended period, the code has not been entered properly or the wrong code has been entered.

Start again from step 2.

5Point the RU151 at the TV and check that it responds as it should.

–If the TV responds to all of the key commands, the RU151 is ready for use. Do not forget to note your code.

•If the device does not respond at all, or not to all of the

key commands, start again from step 2 and try the next code from the list.

5