PR0930x4 3/1/02 10:21 AM Page 3
HOOKING UP YOUR TV (ANTENNA/CABLE CONNECTIONS) (CONT’D)
VCR TO TV
BASIC CONNECTION
T he basic Antenna/Cable to VCR to TV connection is
shown here. If you have a Cable Box, refer to the VCR owner’s manual for details.
Connect your Antenna or Cable signal to the ANTENNA IN jack on the VCR.
Connect a coaxial cable (not supplied) to the RF OUT or ANTENNA OUT jack on the VCR and to the ANT(enna) IN jack on the TV.
Refer to the VCR owner's manual for other possible connections and for operating details.
300 to 75Ω
OutdoorAdapter
VHF/UHF
Antenna
Back of VCR
Coaxial cable
OR
ANTENNA IN | RF/ANTENNA OUT |
| PAUSE | RECORD |
| REW | PLAYF.FWD |
Cable TV signal | POWER VCR/TV |
|
CHANNEL | STOP/EJECT | |
MENU | STATUS/EXIT |
VCR
(example only)
ANT. IN
AC 120V
Back of TV
CABLE TV
CABLE/CABLE BOX
Your Cable TV signal may be a single (75Ω ) cable or a Cable Box installation. In either case, the connection to the TV
is very easy.
If you do not have a Cable Box, then you're ready to connect your Cable TV sig- nal to the TV. Go to step 2.
If you have a Cable Box: Connect the Cable TV signal to the IN jack on the Cable Box.
If you do not have a Cable Box, connect the Cable TV signal directly to the ANT(enna) IN jack on the TV.
If you have a Cable Box: Use a coaxial cable (not sup- plied) to connect the OUT jack of the Cable Box to the ANT(enna) IN jack on the TV.
SMART
HELP
To select 
only the channels on your Cable system, see Auto Install (page 5).
If you use a Cable Box, set the TV to the same channel as the CH 3/4 switch on the back of the Cable Box. Select channels at the Cable Box.
Note to the Cable TV System Installer: This reminder is provided to call the Cable TV system installer’s attention to Article
Cable TV Signal (75Ω )
Cable TV Company
OR
IN
OUT
Cable Box | Coaxial cable |
ANT. IN
AC 120V
Back of TV
- 3 -