Philips RC136/17 manual Connections

Page 6

rc1364101 (1) 4/30/03 3:41 PM Page 6

Connections

Example of placement of RF Receiver on the DSX5500/5540 Receiver.

Digital Multi-Satellite Receiver

MENUINFOOKPOWER

1.Locate the IR sensor on your DSX5500/5540 unit. It is positioned 0.5 inches to the right of the red LED showing when the satellite receiver is powered on. Remove the backing on the IR emitter supplied with the RC136/17, and affix to the bezel in front of the IR sensor as shown in the illustration above.

2.Connect the other end of the IR emitter cable into the IR emitter jack on the RF receiver.

3.Plug the power cord to the RF receiver, and plug the AC adapter into a wall power outlet, as shown in the illustration below.

Note: As long as the IR emitter cable reaches the IR sensor, you are not limited as to where you place the RF receiver.

Note: For instructions on connecting the receiver to your TV or changing the remote control ID, please refer to the Owner’s Manual for the DSX5500/5540.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Directions for Use Your unit may cause an electrical shock. For the safety Congratulations on your purchase, and welcome to the family Table of Contents Safety Instructions- Read Before Operating Equipment Package Contents Connections Remote Control Set-Up Replace the coverSatellite Functions SATMute PowerTV Functions TV InputVCR/DVD Functions Programming the Universal Remote Control Programming the Universal Remote Control cont’d Automatic SearchUniversal Remote Codes Universal Remote Codes cont’d TV Codes Cont’dVCR Codes VCR Codes Cont’d DVD CodesLimited Warranty WHO is COVERED?
Top Page Image Contents