Philips SBCRU530 Automatically setting the remote control, Then keep keys 1 and 3 on the RU530

RU530_87.qxd 04-06-2004 16:57 Pagina 6

English

Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device,

the remote control can automatically search for the right code.

Example of TV:

1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).

The RU530 emits the ‘switch off TV’ signal for all models of TV that are

stored in the memory.

•If the device is a video recorder, insert a tape and start playback.

2 Then keep keys 1 and 3 on the RU530	ME	NU		K
pressed simultaneously for three seconds,				O
until the green light under TV in the selector	1		2	3
window flashes twice and then remains lit.	4		5	6
	7		8	9
	SHIFT		0

3Press the Standby key of the RU530 briefly.

		TV	VCR	SAT
–	The RU530 now starts emitting all known
	‘TV off ’ signals, one by one.
	Each time a code is sent, the green light under	TV	VCR	SAT
	TV in the selector window lights up.
4	When your TV switches off (stand-by),
	you press the Standby key of the RU530
	twice within 1 second, to confirm.	TV	VCR	SAT

–The RU530 has now found a code that works on your TV.

5Check if you can operate all functions on your TV with the RU530.

•If this is not the case, you can redo the automatic setting. The RU530 will then search for a code that perhaps works better.

–After the RU530 has run through all the known codes,

the search will stop automatically and the green light will stop flashing.

–Automatic programming of a TV takes a maximum of 5 minutes.

For VCR this time is 2 minutes and for SAT 4 minutes.

6