Cable box, satellite, Channel, Aim the remote

CBL/SAT	Cable box, satellite
	receiver, Internet Protocol
	TV (IPTV), Free To Air TV,
	High Definition Television
	decoder (HDTV) and TiVo

Example: setting up the universal remote

1		control to operate your TV:
	Switch ON the TV manually or use the
	original remote control for this. Tune to
2	channel 1.
	Press and hold the		5 sec.
		deviceselection
	button for 5 seconds
	until the red Setup
	light	blinks.
	•	The remote
		control is now in setup mode.
3 Look up the 4-digit
	code for your brand
	in the brand list at
	the back of this user
	manual.
	A 4-digit code is
	shown for each brand.
	Use the digit
	buttons to enter the
	code for your brand.
	• If the red Setup
		light turns off,
		an invalid code
4		was entered. In this case, try again.
	Aim the remote		5 - 60 sec.

control at the TV. Press and hold the

button.

Release it immediately as soon as the TV switches off.

•This step normally takes between 5 and 60 seconds. In extreme circumstances this step can take up to 15 minutes.

5 Switch ON the TV.

Try out the buttons you need for operating it.Try, for example, if the

- CH + and digit buttons function properly.

• If a button does not work as expected, press and hold that button. Release it immediately as soon as it works. For more information, see chapter 2.2.2.

6 Press the

	device selection
	button twice to
	finish setup.	2 x
	• When no	2 x
	• When no
	button is
	pressed for 5 minutes or more, the
	remote control will exit setup mode,
	automatically saving all your settings.

Important

If you made a mistake:

•Press the device selection button twice to exit setup.

The red Setup light turns off.

•Restart from the beginning.

•If the device does not respond at all or not to all of the button commands or if you cannot find the code for your brand, enter ‘9, 9, 9, 9’ in step 3 and continue with step 4.The remote control will now search its full database for a code that works with your TV. Full database search may take up to 15 minutes.

2.2.1 Setting up the remote control for other devices (DVD player / recorder and Cable / Satellite box)

1 Make sure the device is switched on and operational. E.g. insert a disc in the DVD player / recorder.

2Then follow steps 2 to 6 of ‘Setting up the universal remote control to operate your TV’. Make sure to use the correct device

selection button: or .

Getting started English

CBL/SAT