Philips SRP5004/86 manual Learning button functions, Resetting a button to its original function

5 sec.

3.2Learning button functions

If you miss certain functions from your original remote control on the SRP5004, the SRP5004 can learn these functions. You can store a function under any of the available buttons, except under the device selection buttons

( ) and the button. Any function already stored under a button will be deleted.

The SRP5004 is equipped with two dedicated buttons for learning additional functions: and . These buttons do not have a default function and enable you to add extra button functions without deleting any SRP5004 functionality.

1 Make sure that you have the original remote control at hand.

2 Select the desired device

(e.g. DVD). Press the

device selection button to select DVD.

• The button lights up.

3Place both remote controls

on a flat surface (like a table) and aim them head-to-head with about 5 - 10 cm in between.

4 Keep the button and the button you wish to learn on the SRP5004 (e.g.

the button) pressed simultaneously for 5 seconds, until the red Setup LED lights up.

•The remote control is now in learn mode.

5Press and hold the button that you wish to learn on the

original remote control until the device selection button gives two short blinks and both button and Setup LED go out to confirm that learning was successful.

•The remote control has now learned the new function.

Note

•It may occur that learning a button function fails the first time.The device selection button will then give a long blink and both button and Setup LED will go out. In this case, please try again.

•If you keep having trouble learning button functions, check the batteries in both SRP5004 and original remote control and replace if necessary.

•It may also be that the remote control learn memory is full (a total of 60 buttons can be learned). In this case you can reset one or more buttons to their all original functions in order to create memory space. For this, see chapter 3.3.

3.3Resetting a button to its original function

If an improved button (see chapter 2.2.2) still does not function as expected, you can always reset the button to its original function. When resetting a button to its original function, any learned function stored under the button will be deleted.

1	In the current device		5 sec.
	mode, keep digit buttons
	and	pressed
	simultaneously for 5 seconds,
	until the red Setup LED
	lights up.
2	• The remote control is now in setup mode.
	Press digit buttons ,		,
	and	, in that order.

• After each button press

the device selection button blinks once.

3 Press the button you wish

to reset twice. E.g. the 22
button.
• After each button press	2 x
the device selection
button blinks once.

•The device selection button will blink one more time to confirm that the button was succesfully reset to its original function.

•The button can now also learn a new function, if desired.

Using the universal remote control English

10 EN EN 11