Philips Guide to Direct Code Entry for Universal Remote Controls

Direct Code Entry

Code Search by Brand

1.Press and hold SETUP until the indicator remains on, then release SETUP.

2.Repeatedly press SELECT to select the desired mode (TV, VCR, etc.), unless the desired mode is already selected.

3.Enter the 4-digit code from the code tables (on separate sheet). Note: After a valid code entry, the indicator turns off. For an invalid code, the indicator flashes.

4.Press CHANNELUP. If the device responds, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes for your brand.

Code Search

If your product does not respond after you have tried all the codes for your brand or if your brand is not listed, try searching for your code by following these steps.

1.Turn on the device (TV, VCR, etc.) to be controlled.

2.Press and hold SETUP until the indicator remains on, then release SETUP.

3.Repeatedly press SELECT to select the desired mode (TV, VCR, etc.), unless the desired mode is already selected.

4.Press CHANNEL UP repeatedly (up to 300 times) until the device to be controlled changes channels. The indicator blinks off with each button press.

5.Press and release MUTE to install the code.

Most users store VCR codes under VCR. Cable codes appear under CBL (Cable), etc.

If you want to store a VCR code under CBL, first follow the procedure for Direct Code Entry and select CBL in Step 2 of Direct Code Entry. Then enter any VCR code in Step 3 of Direct Code Entry. Then follow the steps above for Code Search.

Note: If the device does not have a CHANNEL UP button, use PLAY (VCR only) or POWER instead. Code search begins from the currently stored 4-digit number under that mode.

8

Lets you search for a code for a specific Brand within the Code Library for a particular manufacturer.

1.Turn on the device (TV, VCR, etc.) to be controlled.

2.Press and hold SETUP until the indicator remains on, then release SETUP.

3.Repeatedly press SELECT to select the desired mode (TV, VCR, etc.), unless the desired mode is already selected.

4.Press and release the numeric button (0-9) corresponding to desired Manufacturer (see table on code list sheet). The green indicator blinks off once. Note, pressing “0” performs a full library search same as normal Code Search Method on previous page.

5.Press the CHANNEL UP button ((or POWER or PLAY (VCR only)) repeatedly until the device to be controlled changes channel. The green indicator blinks off with each button press. If you accidentally overshoot the code required, press the CHANNEL DOWN button to backtrack through the library until the device changes channel. Pressing CHANNEL UP changes direction to forward again.

6.Press and release MUTE to install the code.

Brand Search Method entry is now complete. Note: When all codes under a Brand have been searched the indicator flashes rapidly for 3 seconds.

Code Identification Feature

The Code Identification Feature lets you identify the 4- digit library code stored under your device key.

If you want to find what 4-digit code is stored under any device mode, follow these steps.

1.Press and hold SETUP until the indicator remains on, then release SETUP.

2.Repeatedly press SELECT to select the desired mode (TV, VCR, etc.), unless the desired mode is already selected.

3.Press and release SETUP. The indicator blinks.

4.To find the first digit for the code stored under the mode selected in Step 2, press each number button (0-9). When the indicator blinks off, the number you pressed is the first code digit you are searching for.

5.To find the second digit, repeat Step 4. When the indicator blinks off, this is the second digit.

6.Repeat Step 4 to find the third and fourth digits.

9