Philips SLV4200/12 manual Frequently asked questions

Page 14

5Frequently asked questions

www.philips.com/support

In this chapter, you will find the most frequently asked questions and answers about your product.

No image or wrong image on TV1

Make sure the video source is switched on.

Make sure the video source is connected to the transmitter (A).

Make sure the transmitter (A) is connected to TVI.

Make sure the transmitter (A) is switch on.

Make sure SCART cables are firmly inserted.

Make sure the correct SCART input on TV1 is selected.

No image or wrong image on TV2

Make sure SCART cables are firmly inserted.

Make sure the receiver (B) is connected to TV2.

Make sure both receiver (B) and transmitter (A) are switched on.

Make sure the video source is switched on.

Make sure the correct SCART input on TV2 is selected.

If the video source gives proper image on TV1, make sure the video source gives video signal in CVBS mode.

Change the wireless channel that is used for communication.

See “Remove interference on TV2” on page 12.

The receiver (B) is out of range of the transmitter (A). The number of walls and ceilings between the receiver (B) and transmitter (A) restricts the distance.

Interference in the image on TV2

Slightly change the position of the receiver (B) or the transmitter (A).

Change the wireless channel that is used for communication.

See “Remove interference on TV2” on page 12.

The receiver (B) is out of range of the transmitter (A). The number of walls and ceilings between the receiver (B) and transmitter (A) restricts the distance.

The video sources do not respond to the remote control commands from TV2

Point the remote control directly to the receiver (B).

Replace the batteries of the remote controls with new ones.

Install the remote control blaster cord

(F).

See “Install the remote control blaster cord” on page 10.

Note: The maximum operating distance of the remote control is 7m.

Buzzing sound when you use the remote control.

Slightly change the position of the receiver or the transmitter until the buzzing sound stops.

14

Frequently asked questions

Image 14
Contents SLV4200 Page Table of contents Power requirements ConformityPackaging information Electric, Magnetic and Electromagnetic Fields EMFInstallation requirements Control and display elements 1 Source switch Your Wireless TV linkOverview of the Wireless TV link What’s in the boxControl and display elements Getting started Connect transmitterInstall the remote control blaster cord Connect receiverEnjoy Improve the quality of the reception with the antenna Select SourceRemove interference on TV2 Receiver Technical DataTemperature range Relative humidityFrequently asked questions Frequently asked questions Glossary Warranty One year limited warrantyInformation Index Declaration of Conformity