5Frequently asked questions
www.philips.com/support
In this chapter, you will find the most frequently asked questions and answers about your product.
No image or wrong image on TV1 Make sure the video source is switched on.
Make sure the video source is connected to the transmitter (A). Make sure the transmitter (A) is connected to TVI.
Make sure the transmitter (A) is switched on.
Make sure SCART cables are firmly inserted.
Make sure the correct SCART input on TV1 is selected.
No image or wrong image on TV2 Make sure SCART cables are firmly inserted.
Make sure the receiver (B) is connected to TV2.
Make sure both receiver (B) and transmitter (A) are switched on. Make sure the video source is switched on.
Make sure the correct SCART input on TV2 is selected.
If the video source gives proper image on TV1, make sure the video source gives video signal in CVBS mode.
Change the wireless channel that is used for communication.
See "Remove interference on TV2" on page 10.
The receiver (B) is out of range of the transmitter (A). The number of walls and ceilings between the receiver (B) and transmitter (A) restricts the distance.
Interference in the image on TV2 Slightly change the position of the receiver (B) or the transmitter (A). Change the wireless channel that is used for communication.
See "Remove interference on TV2" on page 10.
The receiver (B) is out of range of the transmitter (A). The number of walls and ceilings between the receiver (B) and transmitter (A) restricts the distance.
The video sources do not respond to the remote control commands from TV2
Point the remote control directly to the receiver (B).
Replace the batteries of the remote controls with new ones.
Install the remote control blaster cord (D).
See "Install the remote control blaster cord" on page 10.
Note: The maximum operating distance of the remote control is 7m.
Buzzing sound when you use the remote control.
Slightly change the position of the receiver or the transmitter until the buzzing sound stops.
E n g l i s h
Frequently asked questions | EN13 13 |