Audio- and video equipment keys

VCR DVD SAT AMP CD

†

v Select

Ò ‡ π

æb

This system remote control operates the following Philips equipment:TV,VCR, DVD, SAT (RC5), AMP (+TUNER), CD;

Press the Select key to operate any of the equipment indicated in the display. Another device can be selected by pressing Select repeatedly within 2 seconds. The led will blink slowly to indicate the device.

Press one of the keys on the remote control to operate the peripheral equipment. To return to TV mode press Select while the led is blinking.

When no action is taken within 60 seconds, the remote goes back to TV mode.

Note: When the Select key is pressed and held for more than 2 seconds, the RC5/RC6 system select command is transmitted.

SMENU

+ +

V ¬ P

- -

1 2 3

4 5 6

7 8 9

i 0 0

Active Control

b h q

Bto switch to standby

Sfor pause (VCR, DVD, CD)

®for record,

Òfor rewind (VCR, CD); search down (DVD, AMP)

‡for stop

πfor play

†for fast forward (VCR, CD); search up (DVD/AMP)

æto select your choice of subtitle language (DVD); RDS news/TA (AMP); to shuffle play (CD)

bto select a dvd title;

RDS display (AMP); info on screen (CD)

idisplay information

MENU to switch the menu on or off

-P+for chapter, channel, track selection

0 to 9 digit entry

0tape index (VCR), select a DVD chapter, select a frequency (AMP)

UVCR timer

Qsurround on/off (AMP, CD)

cursor up/down

to select the next or the previous disc (CD)

cursor left/right

to select the previous or following track (CD) search up/down (AMP)

Additionally the DVD, SAT and CD indicator can be programmed to operate the DVD-R, SAT (RC6), CD-R instead.

&Press the Select key repeatedly until no LED is lit.

éTo program DVD-R, press the OK key + digit 2.

To program SAT (RC6), press the OK key + digit 4. To program CD-R, press the OK key + digit 6.

From now on, when the corresponding (DVD, SAT, CD) indicator is selected, the remote control will operate your DVD-R, SAT (RC6) or CD-R.

Note:To return to the modes programmed in the factory, either remove the batteries for a few minutes, or press the OK key + digit 1 (DVD mode); or + digit 3 (SAT-RC5) or + digit 5 (CD mode).

Record with your recorder with EasyLink

In TV mode, it is possible to start a direct recording of the programme which is being displayed on the TV screen. Continue to press the ® record key on the remote control for more than 2 seconds.

Note:

Switching programme numbers on your TV does not disturb recording !

When recording a programme from a peripheral connected to EXT. 1, EXT. 3 or SIDE, you can not select another TV programme on the screen.