Change the channel settings, Select a ring

Press to select a category option (HIGH DEFINITION, SPORTS, NEWS, etc) to save the channel.

Press to select YES to save the channel to this category or NO to remove the channel.

4Change the channel settings

This section describes how to change the channel settings.

1Press M on the setup remote control to display the setup menu.

2 Press to select CHANNEL INSTALL > CHANNEL.


3	Press 0-9 (Numeric buttons) to select a channel.
	•	For cable mode, select a number between 01 - 250.
4	•	For antenna mode, select a number between 02 - 250.
	Press to select INPUT, and then press		to select the source

of input.

1Press M on the setup remote control to display the setup menu.

2 Press to select CHANNEL INSTALL > DIGITAL > YES.

3Press to set the RF CHANNEL NUMBER to the physical channel number.

4 Press 0-9 (Numeric buttons) to enter the physical channel number.

5 Press to set the MPEG PROGRAM NUMBER to a particular program in the physical channel.

6 Press 0-9 (Numeric buttons) to enter the program number.

Note

••You can also select DIGITAL CH SCROLL and press to select the digital channel numbers.

1Press M on the setup remote control to display the setup menu.

2 Select the channel that you want to save in a ring and the input

source (see ‘Manual installation of analog channels’ on page 4).

3 Press to select CHANNEL INSTALL > RINGS.

4Press to select a ring number.

»» A flashing red dash appears next to the selected ring.

5Press to save or remove a channel from the ring.

»» The ring is marked by an ‘X’ when the channel is saved in it.

4EN