Philips BDL4650E Mounting in Portrait Position, How to use the logo guider for portrait position

Page 12

BDL4250EL / BDL4650EL

1.6.Mounting in Portrait Position

This display can be installed in portrait position.

1.Remove the table stand, if attached.

2.Rotate 90 degrees clockwise.The “” logo should be on the LEFT side when facing the display.

90

90

1.6.1. How to use the logo guider for portrait position

1. Put the guider on the lower-left corner of the front bezel of the display. Fold down both of its edges.

2. Peel off the protective film at the back of the “” logo sticker.

Hold and press the guider with your left hand. Put the “” logo sticker with its adhesive side down into the logo hole with your right hand, and press to make it stick tightly onto the front bezel.

3. Remove the guider.

1.6.2. How to remove the logo

	1. Prepare a piece of paper with a cutting area of logo as a protector to	1	2	3
	prevent the front bezel from scratching.

2. Using a knife, carefully remove the logo sticker with the paper placing beneath.

3. Tear off the logo sticker.

NOTE: When installing the display on a wall, please consult a professional technician for proper installation.We accept no liability for installations not performed by a professional technician.

4

Image 12

Contents BDL4250EL BDL4650EL Safety Instructions Know These Safety SymbolsRegulatory Information CE Declaration of ConformityFederal Communications Commission FCC Notice U.S. Only Polish Center for Testing and Certification Notice Electric, Magnetic and Electronmagnetic Fields EMFHow to connect a plug Information for U.K. only中国电子信息产品污染控制标识要求中国RoHS法规标示要求产品中有毒有害物质或元素的名称及含量 China RoHSNorth Europe Nordic Countries Information End-of-Life DisposalWaste Electrical and Electronie Equipment-WEEE For customers in Canada and U.S.ATable Of Contents Unpacking and Installation Package ContentsInstallation Notes UnpackingInstalling and Removing Table Stands optional To install table standsTo remove table stands Mounting on a Wall Vesa GridVentilation Requirements for enclosure locating How to use the logo guider for portrait position How to remove the logoMounting in Portrait Position Remove the guiderParts and Functions Control PanelInput/Output Terminals Remote Control General functionsInserting the batteries in the remote control Handling the remote controlOperating range of the remote control Connecting External Equipment Using the Switch CoverConnecting External Equipment DVD/VCR/VCD Using Component video inputUsing Video Source input Using Hdmi video inputConnecting a PC Using VGA inputUsing DVI input Using Hdmi inputConnecting Audio Equipment Using DisplayPort inputConnecting external speakers Connecting an external audio deviceConnecting Multiple Displays in a Daisy-chain Configuration Display control connectionDigital video connection Analog video connection OSD Menu OSD Menu OverviewNavigating the OSD Menu Screen menu Audio menu PIP menuPosition Configuration1 menu Configuration2 menu Advanced option menuScan mode Film modeHdmi clock threshold Black level expansionFrame comp. -Yes Frame comp. No Heat statusDate and time ScheduleHdmi with One Wire Smart powerAuto signal detection Monitor IDAdvanced option reset APMInput Mode VGA ResolutionSdtv Resolution Hdtv ResolutionDot definition = What is a defective Dot? Pixel Defect PolicyPixels and Sub-Pixels Types of Pixel Defects + Dot DefinitionDark Dot Defects Proximity of Pixel DefectsPixel Defect Tolerances MuraCleaning and Troubleshooting CleaningFront Panel Cleaning Instructions Cabinet Cleaning InstructionsTroubleshooting Technical Specifications BDL4250ELDisplay In/Out TerminalsEnvironmental Condition Internal SpeakerBDL4650EL Environmental Condition