Update channel list
When the TV was switched on for the first time, a full installation of channels was performed.
You can automatically add or remove digital channels or manually update channels.
Note: If you are prompted to enter a code, enter '8888'.
Automatic update
To automatically add or remove digital channels, leave the TV in standby mode. The TV updates channels and stores new channels everyday. Empty channels are removed from the channel list.
If a channel update is performed, a message appears at startup.
If you do not want this message to appear
1.Press .
2.Select [Setup] > [Channel settings] or
[Satellite settings].
3.Select [Channel installation] > [Channel update message].
4.Select [Off], then press OK.
To disable automatic updates
In the [Channel installation] menu, select [Automatic channel update] > [Off].
To manually update channels
1.Press .
2.Select [Setup] > [Search for channels] >
[Update channels], then press OK.
3.Follow the onscreen instructions to update the channels.
Automatic install
When the TV was switched on for the first time, a full installation of channels was performed. You can run this full installation again to set your language, country and install all available TV channels.
Select network
To install cable or antenna channels, you need to switch to the respective network.
1.While you watch TV, press .
2.Select [Setup] > [Channel settings].
3.Select [Channel installation] > [Antenna or Cable DVB].
EN 40
4. Select one of the following settings:
∙[Antenna
∙[Cable]: Access cable or digital
5.Press OK to confirm.
6.Press to exit.
Start installation
1.Press .
2.Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
3.Follow the onscreen instructions to complete the channel installation.
4.Once complete, select [Finish], then press OK.
Tip: Press FIND to see the channel list.
Notes:
∙During installation, leave settings unchanged unless your digital provider gives you the specific values to enter.
∙When digital TV channels are found, the list of installed channels may display empty channel numbers. You can rename, reorder or uninstall these channels.
Install analogue channels
You can search and store analogue TV channels manually.
Step 1: Select your system
Note: Skip this step if your system settings are correct.
1.While you watch TV, press .
2.Select [Setup] > [Channel settings] >
[Channel installation].
3.Select [Analogue: Manual installation] > [System], then press OK.
4.Select the system for your country or region, then press OK.
Step 2: Search and store new TV channels
1.In the [Analogue: Manual installation] menu, select [Find channel], then press OK.
2.Select one of the following options: