TV menu-Installation
Installation | 7 | Language | 3 |
Language |
| English |
|
Autoprogram |
| Français |
|
Source |
| Español |
|
Clock
Weak channel installation
Current software info
Reset AV settings
Info
Select the menu language
1 | Press the MENU button on the remote control. |
2Use the cursor down to select Installation in the Settings menu.
3 Use the cursor right to enter the Installation menu.
4 Select Language and enter the list of available languages with the cursor right.
5 Select your preferred language with the cursor up/down and press the OK button to confirm your selection.
6 Proceed with the Installation menu.
Store TV channels
1
Select Autoprogram in the Installation menu.
2Use the cursor right to enter the Autoprogram menu.
Installation | 7 | Autoprogram | 2 | 3 Select Cable or Antenna in the Installation mode. | |
Language |
| Antenna |
|
| When Antenna is selected, the TV will detect antenna |
Autoprogram |
| Cable |
|
| signals and will search for antenna TV (NTSC and ATSC) channels |
Source |
|
|
|
| available in your local area. |
|
|
|
|
| |
Clock |
|
|
|
| When Cable is selected, the TV will detect cable company |
Autoprogram |
| 2 | Antenna |
| |
|
|
| |||
Weak |
|
|
|
| supplied signals and will search for cable TV (NTSC, ATSC, QAM |
Curre t software info |
|
|
|
| |
Antenna |
|
|
|
|
|
Cable |
|
| Start now |
| modulated) channels available in your area. |
Reset AV settings |
|
|
|
|
Make sure that registration with your cable TV provider and
Info
Info
Television Installation
connection of equipment are completed.
4Select Start now with the cursor right key.
5 Press the OK button.
6 Press the green button “Start” to start Autoprogramming. The menu screen disappears and the progress of Autoprogramming is displayed. The progress bar indicates the number of analog and digital TV channels found.
Auto programming may take up to 20 minutes to complete. Digital channels will take longer than Analog to find and program. Please
You can now start automatic installation. This procedure can take more than half an hour.
wait until you see the Auto Programming complete message. The TV will then switch automatically to the first channel found.
Note: All channels must be unlocked in order to autoprogram. If requested, enter your PIN code to unlock all channels. (p. 25)
Previous Start
Notes:
•When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in order to complete Autoprogramming.
•ATSC channel information is updated automatically when the TV is in standby after 3 minutes and every 3 hours thereafter.
•When channel update is interrupted, the new updated channel information is retained along with the old
•Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.
•If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies and update information.
•Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 13.)
•Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
•If Antenna/cable signal is interrupted more than ten minutes, TV will go into off mode. You are requested to press Power button or CH + / - button to turn on the TV.
12